Engine and Transmission

6,497 topics in this forum

1. Oil Change Frequency for 1996-2001, E-7's

   By pdl, October 2, 2014
   • 2 replies
   • 1.3k views
   • 
   • farmer52
   • October 3, 2014

2. splitting 6 speed low hole 1 2

   By mackr1989, September 28, 2014   

   • transmission
   • shift pattern
   • 25 replies
   • 10k views
   • 
   • blackdog2
   • October 3, 2014

3. END673 Pump

   By nasty51ford, August 19, 2014   

   • Turn it up
   • 10 replies
   • 3k views
   • 
   • nasty51ford
   • October 1, 2014

4. Engine oil running hot

   By Jen, September 30, 2014
   • 5 replies
   • 2.2k views
   • 
   • j_martell
   • October 1, 2014

5. What is your actual mpg(local drivers that haul for quarries)

   By dds92780, September 16, 2014
   • 17 replies
   • 4.5k views
   • 
   • TorresTransport
   • October 1, 2014

6. Radiator removal-Vision

   By MVision, September 22, 2014
   • 2 replies
   • 2.4k views
   • 
   • TorresTransport
   • October 1, 2014

7. E7 etech problem

   By dondiesel444, September 25, 2014
   • 6 replies
   • 5.5k views
   • 
   • TorresTransport
   • September 30, 2014

8. Mack 400 poor idle and high rev

   By DSHequipment, September 22, 2014
   • 3 replies
   • 1.3k views
   • 
   • wheeler73
   • September 30, 2014

9. R700 v8 375 oil cooler

   By aemackr7, September 29, 2014
   • 1 reply
   • 1.2k views
   • 
   • BAD DOG
   • September 30, 2014

10. Hot puppy

    By Superliner22_, September 28, 2014
    • 5 replies
    • 1.9k views
    • 
    • Superliner22_
    • September 28, 2014

11. Front seal

    By keg1, September 27, 2014
    • 5 replies
    • 3.1k views
    • 
    • keg1
    • September 28, 2014

12. loose power down to 30 mph

    By eltiablo, September 11, 2014
    • 5 replies
    • 1.6k views
    • 
    • Jamkar
    • September 28, 2014

13. 1995 mack rd688s E7-427

    By winklershop, September 18, 2014
    • 4 replies
    • 2.2k views
    • 
    • winklershop
    • September 26, 2014

14. 1994 E7-400 EMC Module (Bosch Module) gone bad

    By raindog, September 25, 2014
    • 2 replies
    • 2.9k views
    • 
    • jdfordhd
    • September 25, 2014

15. T2070 oil viscosity and capacity

    By woody225, September 24, 2014
    • 2 replies
    • 4.8k views
    • 
    • turckster
    • September 25, 2014

16. E-6 350 fluid capacities

    By Junior9009, September 22, 2014
    • 2 replies
    • 7.1k views
    • 
    • 85snowdog
    • September 22, 2014

17. mack t2180 rear countershaftcover

    By vinny933, September 7, 2014
    • 2 replies
    • 2k views
    • 
    • turckster
    • September 22, 2014

18. 01 cx613 E7 427 running temp

    By bobgil, September 21, 2014
    • 2 replies
    • 1.5k views
    • 
    • turckster
    • September 22, 2014

19. Looking for injector lines for a '57 B-65 673...any hints?

    By Wobblin-Goblin, September 18, 2014
    • 3 replies
    • 1.2k views
    • 
    • Wobblin-Goblin
    • September 22, 2014

20. E7 460 valve set

    By mercuryman, September 14, 2014
    • 1 reply
    • 1.1k views
    • 
    • wilbur
    • September 21, 2014

21. Transmission swap question

    By cheech147, September 11, 2014
    • 12 replies
    • 4.1k views
    • 
    • mm826
    • September 20, 2014

22. Bosch P7100 help (experts needed) Advice wanted

    By dds92780, September 12, 2014
    • 3 replies
    • 2.4k views
    • 
    • gearhead204
    • September 20, 2014

23. Do I have the oil line going into the right place its a 711END

    By ejensen21, September 16, 2014
    • 3 replies
    • 1.4k views
    • 
    • 68MackR
    • September 17, 2014

24. Big oil leak on turbo

    By rightsaidfred, September 14, 2014
    • 2 replies
    • 1.2k views
    • 
    • gearhead204
    • September 14, 2014

25. E-6 350

    By Junior9009, September 13, 2014
    • 2 replies
    • 1.5k views
    • 
    • Vladislav
    • September 13, 2014