Jump to content

Retreads on steers


Recommended Posts

I know there is a stigma against running retreads on steer axles over the road...but what about our hobby trucks? Does anyone run retreads on the front?

I have heard good things about Michelin retreads...I can get Michelin XZA retreads on Michelin casings for $289 in 11R24.5...that is compared to the least expensive new tire I could find, a Yokahama RY617 for $455...

Thoughts and opinions are welcome!

Link to comment
Share on other sites

No caps on steer tires PERIOD! can't emphasize enough just how dangerous that could be! there have been many significant improvements in caps over the years,longevity,safetywise,but not for use on the steer axle! better to spend the money on a good set of seconds.......................................Mark

I agree with this for a work truck.

But, just how much "hobby" are you talking? If the local shows, Don't see a big problem.

If you are looking to Macungie or other distance, I wouldn't

Success is only a stones throw away.................................................................for a Palestinian

Link to comment
Share on other sites

398.5 (E) (e) Tires. Every motor vehicle shall be equipped with tires of adequate capacity to support its gross weight. No motor vehicle shall be operated on tires which have been worn so smooth as to expose any tread fabric or which have any other defect likely to cause failure. No vehicle shall be operated while transporting passengers while using any tire which does not have tread configurations on that part of the tire which is in contact with the road surface. No vehicle transporting passengers shall be operated with re-grooved, re-capped, or re-treaded tires on front wheels.

This is all i could find on caps.

  • Like 1

glenn akers

Link to comment
Share on other sites

 

398.5 (E) (e) Tires. Every motor vehicle shall be equipped with tires of adequate capacity to support its gross weight. No motor vehicle shall be operated on tires which have been worn so smooth as to expose any tread fabric or which have any other defect likely to cause failure. No vehicle shall be operated while transporting passengers while using any tire which does not have tread configurations on that part of the tire which is in contact with the road surface. No vehicle transporting passengers shall be operated with re-grooved, re-capped, or re-treaded tires on front wheels.

This is all i could find on caps.

 

Either way! It's not a good idea! Spend the extra $$$ on the new fronts and get the lesser expencive for the drives!

Link to comment
Share on other sites

 

398.5 (E) (e) Tires. Every motor vehicle shall be equipped with tires of adequate capacity to support its gross weight. No motor vehicle shall be operated on tires which have been worn so smooth as to expose any tread fabric or which have any other defect likely to cause failure. No vehicle shall be operated while transporting passengers while using any tire which does not have tread configurations on that part of the tire which is in contact with the road surface. No vehicle transporting passengers shall be operated with re-grooved, re-capped, or re-treaded tires on front wheels.

This is all i could find on caps.

Maybe this means you can run them on a truck as long as you don't have anyone in the passenger seat. Ok to endanger yourself just don't take anyone with you. I remember a guy that was running caps on his DM's. When the first one came apart and took half the hood with it, he changed his mind.

Link to comment
Share on other sites

Ran Bandag caps on the drives and swore by them.Now, steer axle........ NEVER! Spend the extra $$$$ get GOOD virgin steer tires. The amount of safety built in to that decision,will let you sleep and motor in peace!

IF YOU BOUGHT IT, A TRUCK BROUGHT IT..AND WHEN YOU'RE DONE WITH IT, A TRUCK WILL HAUL IT AWAY!!! Big John Trimble,WRVA

Link to comment
Share on other sites

In my area...

Commercial trucks and buses...

which are subject to annual or semi-annual "Commercial Vehicle Safety Enforcement" independant inspection.

Recap, retread, remould or re-grooved tires are illegal on an 'active' steer axle

Retreads can be used on 'passive' self-steering axle..

light vehicles (except taxi or bus)..

no annual inspection, owner rsponsible for condition and maintenance.

re-tread accepted on steer axle... (but you will rarely see them due to market conditions)

now, what is a "hobby truck"...???!!!!!

here in BC, they are technically classified as a 'private truck' ONLY if used for personal and non-commercial use... there is a further classification of 'collector car' which is confusing as a bus or class 8 truck is included if it meets reuirements...if you pull a private trailer with your other private truck loaded on it.. well, then it becomes an issue which could requires some discussion with the gubberment, usually a less frequent commercial inspection is called for due to concerns of weight and brakes.... and these are on a case-by-case basis.

I have seen 'exemption' letters for approved variances on a few specialist trucks and some have included tires but they were slow moving vehicles. I think the local 'Hayes' club has a 3 year inspection.

if you want to run a non-commercial hobby truck with non-virgin tires on the steer axle then you may want to consult your state motor vehicle act, as there will obviously be differences state to state, and may be determined by gvw regardless of use.

here's one to ponder..!!!! would you rather have fresh namebrand recaps on the front steer... or... virgin tires with a 15 year date code????? hmmmm

BC Mack

Link to comment
Share on other sites

I do not like caps but I'm going to recap my drive tires on the rw since they are all matching cases with no defects and I don't use it commercially. Here in TN you won't pass a DOT with a cap on a steer, and I have heard of a truck getting shut down in Manchester for caps on the steer. I would never do it period, its not that much more money to get a set of Roadmaster RM 180 steer tires they aren't the best but they'll work and last a long time on a hobby truck.

"Any Society that would give up a little LIBERTY to gain a little SECURITY will Deserve Neither and LOSE BOTH" -Benjamin Franklin

"If your gonna be STUPID, you gotta be TOUGH"

"You cant always get what you want, but if you try sometimes you get what you need"

Link to comment
Share on other sites

Leslie - likely the Michelins will be okay but as others posted, invest in a good set of virgin tires, check the toe-in, and keep them balanced. In the back of my mind I think about a front tire blowout when bobtailing (especially with a single axle tractor).

I am sure you checked the internet for best pricing. There is a shop in Chambersburg PA that has good prices on Michelin tires. I don't remember the name but I will look for it if you are interested. Don't forget, your current tires may be worth some money (if the casings are good).

Ken

PRR Country and Charter member of the "Mack Pack"

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...