terry
-
Posts
2,431 -
Joined
-
Last visited
-
Days Won
1
Content Type
Profiles
Forums
Gallery
Events
Blogs
BMT Wiki
Collections
Store
Everything posted by terry
-
So what did you use for axles on rear end pumpkin swap? Terry.
-
ENDT 675 priming after fuel filter change
terry replied to Old_DM's topic in Engine and Transmission
Just fill filters completely up, and pump primer till hard, should start, might miss for a few seconds but should clear up. Terry -
The trdl1070 would work good behind a 237 or 285, but the X107 six speed would not be good behind a 350, to much lugging for that engine. Terry
-
What model is the dump truck? Chances are the 75 is just a x107 six speed which will not work good with a 350 engine, need to check rear ratios to see if there the same. Terry
-
Is this a single axle, or tandem, single axle on the older Mack’s can be front or top mounted? Terry
-
I would say the R 614 is the ratio. Terry
-
I have run into that greased inner bearing, and oil outer bearing with the middle seal on a B model Mack, just eliminated the middle seal and a different inner seal, and was good to go, terry
-
I believe some old international’s had the front end, I think they were part of Mack at one time. Terry
-
Definitely a couple of hard raps on top of u-bolts after assembly will tighten a little more! Terry
-
I believe that is what they call semi-round u- bolts. terry
-
Mack r600
terry replied to Nick mack rd686s's topic in Antique and Classic Mack Trucks General Discussion
I bet them ground guys got a royal chewing out! Terry -
Looks like he already had it rebuilt. Terry
-
Don’t know for sure, old Mike harbison would have been able to answer that, lost a lot of Mack info when he passed. Terry
-
That’s a B70 something, so a longer hood. Terry
-
You’re doing good Heinz!👍. Terry
-
R Model Farm Truck
terry replied to seyser's topic in Antique and Classic Mack Trucks General Discussion
Could have made your own with some gasket material 😁 terry -
Camelback can have the transverse rods, i guess it depends if it was ordered that way or put on later. terry
-
I wonder if you do that cross torque rod you should do it on both rear ends, I have seen where it was added on the back rear only and the frame cracked between the two holes drilled in the frame for the bracket? Terry
-
I do believe in the 70’s you could get a Detroit in a R model. Terry
-
The slightest crack in a return line will let it bleed off, Terry
-
Yeah that is a newer style, than I was thinking of. Terry
-
The lift pump I am thinking was on the older engines, E7 might be completely different.🤷♀️. Terry
-
A pic would help
-
Sounds like the lift pump with the plastic check valves, check them first. Terry
-
As far as china made parts, awful hard to get away from, I have bought bearing races from Mack dealer, yeah made in china! Terry
BMT Forum Logo
