terry
-
Posts
2,358 -
Joined
-
Last visited
-
Days Won
1
Content Type
Profiles
Forums
Gallery
Events
Blogs
BMT Wiki
Collections
Store
Everything posted by terry
-
Outstanding job, you done good !! terry -
Must be talking about norm, really a terrific guy! terry
-
Could be a combination of worn spoke, or clamps, the old school remedy was a small spacer that went with the original wheel spacer, think i still have a couple hanging in my garage. terry
-
just a note to say I really like following this adventure! terry
-
I know there have been some changes on the site, just noticed the like button missing, kind of liked it ! guess i better open my eyes! terry
-
Alot depends on working conditions, real clean, or real dirty conditions, goes for all the maintenance items, oil change, air filters and greasing. terry
-
Probably put together from different brands! terry
-
I ran a rough terrain crane in Viet Nam, had the 903 in the carrier, and a 220 in the crane, we had to change the 903 once, that was a real job! terry Also seen alot of the 10 ton trucks with the 903 engine.
-
1986 Mack RW Superliner
terry replied to j hancock's topic in Antique and Classic Mack Trucks General Discussion
One of the best looking R model series, besides the RD800. terry -
Not alot of them, but there out there. terry
-
Remember these from army days in the late 60's, they were a real horse! terry
-
Love that autocar, and quite the 2 cycle engine! terry
-
Bet that 400 series is a scania! terry
-
learn something new everyday! terry
-
Make sure your donor axle has the same spring width and same center bolt hole to hole as the old axle., mack has different widths on these, depending on the model of the truck. terry
-
I thought a mack jr. was a pickup? terry
-
Sounds to be set up pretty good, but a little steep on price i would say. terry
-
1983 Mack superliner transmission swap
terry replied to Lucky dogg's topic in Engine and Transmission
Not a good combo, the 2080 is real wide geared, a 1070 12 spd would be perfect with those rears, I drove a DM dump for years with a 12 spd. and 4.17 rears, would run 65 at 1600 rpm,s terry -
if it still has the gas rears it will be a slow runner. terry
-
Quite the run for a 237!! terry
-
B with a Cummins
terry replied to h67st's topic in Antique and Classic Mack Trucks General Discussion
Like all the 237 mack engines people try to say are 300's. terry -
B with a Cummins
terry replied to h67st's topic in Antique and Classic Mack Trucks General Discussion
Years ago there was a smaller series of cummins engines, i'm sure somebody will post with better info. used to see them in local redimix trucks with automatics. terry -
sharp eye mike, way to many axle studs for a mack rear! terry
-
Isn't it cooler in the northern part of state, thought it might be a little higher elevation. terry
-
looks like you have your work cut out for you! terry lots of work! Be sure to post your completed work
BMT Forum Logo
