Clutch brake

[mechohaulic]

never used one ,but one heck of an ingenious idea. real time saver 

[Geoff Weeks]

Yep, nice tool, but hard to justify the cost unless you do a lot of them. All the ones I have done, I did without the puller.  Can be a pain to get something small enough to get behind the bearing snap ring.

[Freightrain]

At this point $70 Amazon pricing isn't bad.  Lord knows I have wasted more on less.

[Joey Mack]

When the small cover is off, you can strike the end of the input shaft with a dead blow, and the bearing will walk out enough to get behind it.

[mrsmackpaul]

So not knowing what I'm looking at here, this tool pulls the bearing offthe shaft and out of the box while leaving the shaft installed

 

Is that correct, pretty smart idea if my understanding is correct 

I guess the other side of things to think about is, if you have a issue in the box your unaware of, this is the time to have a look while it (the gear box) is on the ground out from under the truck

But.that is a smart tool if my understanding is correct 

 

Paul