Jump to content

T2070 trans


masterwelder
 Share

Recommended Posts

  • 4 weeks later...

The 2060 will fit in the same amount of space the 2070. I had my 2060 changed to a 2070. Same case,different countershafts in compound section. I changed to get the 14. something crawler gear.The 2060 had only a 9. something.Too fast off road for my liking,even with 5.55 rears. Top hole was .60:1 .For work the 2070,was the way to go for me.I could see the 2060 in road truck,though. Vlad, I wasn't aware of different ratios in the 2060 to the 2060A. Thanks.Now you have me wondering! :tease:

  • Like 1

IF YOU BOUGHT IT, A TRUCK BROUGHT IT..AND WHEN YOU'RE DONE WITH IT, A TRUCK WILL HAUL IT AWAY!!! Big John Trimble,WRVA

Link to comment
Share on other sites

Now you got me thinking!!!! My Truck never had a shifting diagram on the dash and the plastic cover on top of the shifting lever was gone also... so I'm not totally sure now if its a 6 or 7??? Rarely needed the low side but when I did I shifted it like a 7 and it worked well.

Is there a place on the trany to look, or can some one run the vin# and tell?

Link to comment
Share on other sites

Any thoughts on how to put it in place of T2090?

Papers tell T2070 is longer and heavier to my surprize.

I probably don't need the nine speed unit for the hobby single tracktor especially the worn one.

Steps look to me too short on my mind in relation to driving a car.

Not shure I need it right now, would have to pay the same amount over for a shipping.

post-3971-0-08036500-1390502207_thumb.jp

post-3971-0-66355200-1390502220_thumb.jp

Никогда не бывает слишком много грузовиков! leversole 11.2012

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...