terry
-
Posts
2,352 -
Joined
-
Last visited
-
Days Won
1
Content Type
Profiles
Forums
Gallery
Events
Blogs
BMT Wiki
Collections
Store
Everything posted by terry
-
I’ll bet at least countershaft bearings are junk. Terry
-
the six speed is a direct trans. would not work good with the older rear ratios, the right model of the old style trasmissions are overdrive in both boxes. terry
-
Have to comment on the trans. Statement about how many gears are needed, you do need more gears with a single counter shaft trans behind the 237 or 285 engine that series of trans will not take the lugging down them engines can do. Terry
-
You also have to use a shorter nosed water pump, and shorter crank hub. terry
-
Nice!!😀 terry
-
Just be sure to run a die on each end of studs and run a bottom tap and blow out stud holes on block. Terry
-
Connecticut Construction Trucks
terry replied to BKrois's topic in Antique and Classic Mack Trucks General Discussion
Awsum! Looks terrific! Terry -
Looking for model and year of truck
terry replied to Stephanie's topic in Antique and Classic Mack Trucks General Discussion
Maybe a variation of a E model? terry -
Leak in return line will let it bleed off. does that supply pump have the two little plastic check valves? if one is bad no pumping fuel. terry
-
Wow they made the B model later there than the U.S. terry
-
His has coolant water through it along with the air, yours is an older air only model. Terry.
-
Them are later tanks than he his looking for, might work with a little fabrication of brackets. terry
-
Data plate says ST, six wheel, tractor. Terry
-
We’re all kicking ourselves on cars that we sold when we were young! Terry
-
Are you supposed to put harder valve seats in an older engine with the unleaded gas now? Terry
-
Probably be a lot cheaper to fix the exhaust. Terry
-
1951 L85 Rear Spoke Wheel rebuild question
terry replied to FireSKip17's topic in Driveline and Suspension
Do you have the middle seal out, seems to me there was a lip in there to press middle seal against. Been along time since I had one of them apart! Terry -
Definitley a new one on me! terry
-
He said no air shift, the 2060,2070 and 2080 all had an air low range flipper on the stick. Terry
-
I was always told if you started it without the lock in it would loosen the clutch 🤷♀️
-
can,t say that I have, I was a Mack dump owner, driver for 40 plus years, so most of my work was on my own truck. I would help in the shop for the company that I worked for once in a while , seems like his mechanic would use a rattle gun with a long bit to knock a stuck one loose. Terry
-
This is a new one on me to adjust. terry
-
Don’t know what kind of clearance you have there, but sometimes you can just slide trans. Back and do your clutch work. Terry
-
1987 Mack Twin Stick
terry replied to jaspencer's topic in Antique and Classic Mack Trucks General Discussion
Counting the lolo in reverse, should be six. Terry -
To many guys try to use silicone and squeezes the gasket out. terry
BMT Forum Logo
