fjh
-
Posts
5,613 -
Joined
-
Last visited
-
Days Won
20
Content Type
Profiles
Forums
Gallery
Events
Blogs
BMT Wiki
Collections
Store
Everything posted by fjh
-
how do i check/adjust puffer valve on '77 676
fjh replied to diggin dirt's topic in Engine and Transmission
three checks! check the throtle make suire it is going all the way to the end of its travel on the pump! 2 - check to be sure the stop cable is going full on! #3 Remove the bimbo slave from the pump and see if this changes your power situation it may be stuck out how ever as Glenn stated it needs air to operate! -
Hopfully just liner orings if thats the case you have 6 more to think about!
-
Did it go bang?
-
Kev Our decision makers are known for their Great decisions! Were just Dam lucky to get that unit! I would have expected them to order up 50000 mountain bikes with machine gun mounts on the handle bars for the guys to use ! Don't forget they did buy the english built subs for our navy! Some huge Military bargains out there you know! OH Wait!!! We had to part out one to make the other one work that's right! So do we have a SUB!
-
Yup the dollar store fix! Volvo Trash!
-
Timing advance solenoid in front the the pump is likely haywire! Also replace the line that feeds the solnoid if its old!
- 1 reply
-
- 1
-
-
It could be the AC switch and The solenoids are also prone to failure even new out of the box we have had a rash of bad ones lately Unplug the green AC switch and wait a minute or so if the fan shuts down that could b your problem.
-
You have to do the cam swap to get the benefit power your doing away with the wasted fuel and some of the turbo lag ,the pre egr manifold will help a tad but not much
-
plugged tank vent
-
2001 Ch612 e7 350 wont start after inframe
fjh replied to bigmike9368's topic in Engine and Transmission
If I remember corectly its in the little fuse box under the hood Drivers side! -
2001 Ch612 e7 350 wont start after inframe
fjh replied to bigmike9368's topic in Engine and Transmission
Check the ecu fuse ! Did it light the either off? If not Did they have the front cover off!? Is it in time? -
Half fuel is normal! is your oil level rising ? the fuel transfer pump may be in its way out!
-
WE have pulled almost 500 hp out of the little Mack E7 12 litre for years don't see why ya cant get 600 from a 13 litre! Other than the fact its a Volvo engine Not a Mack! The sales on the Titan were quite low However they need to offer the 16 litre in one of the other models to keep up. it needs to be an option There Are places here in BC were HP demand is high ! My opinion! They are systematically shrinking MACK market share, Obvious where this is going! The Vocational sector should have been left to the MACK branded units! Not that these Volvo people listen to anyone!
-
Is the clutch brake set where its supposed to be? Right at the floor!! that is the most important first step that is sum times missed! If you set the gap and the brake is not set correctly the angle springs can be at the wrong angle to grip properly ! Depending on which clutch is in there! This is can be common Issue with an easy pedal clutch if not adjusted correctly! An over adjusted easy pedal may slip! Like 204 said It so it sounds like the clutch is simply worn out springs or lining rolling around inside!
-
Do you have teck tool can you watch the temps the scr needs good heat to operate! Soot level good? Good preasure on the doser? All sorts of things can cause this stuff to happen Even a turbo issue , are you in a cold climate? if the heater stops working it will cause the scr not to work and wouldn't tell you why we ran in to this last week! I think Mackpro has got a good handle on this stuff He may chime in here shortly There are several guys here That may point you in the right direction I am not a guru on this crap!
-
We have yet to see catylist failure Chances are you have build up of crystal at the inlet to the def cat box very common! pull it apart and look
-
Drive shaft and stick
-
Ya But the bull gear job aint cheap add that to the rebuild you may just as well do the drop in !
-
-
water cooled tip turbine question
fjh replied to Outbehindthebarn's topic in Engine and Transmission
your 285 Air to air will work just fine in my opinion they took it right up to 315 with that set up! -
water cooled tip turbine question
fjh replied to Outbehindthebarn's topic in Engine and Transmission
What HP Is your engine? the water over air Usually came with a 350! Sorry Can't remember how it was plumbed! I Don't really see the benefit anyway! -
water cooled tip turbine question
fjh replied to Outbehindthebarn's topic in Engine and Transmission
What HP Is your engine? the water over air Usually came with a 350! Sorry Can't remember how it was plumbed! I Don't really see the benefit anyway! -
That year of engine would simply have a throttle and dash switch IS it dynatard or JAKE ? The original dynatard setup would work best for this it is normally activated by engine RPM! Gear down would be how ever the trany is regulated .
-
What year
-
The mack would look good with a scania V8 under the hood anyway !
BMT Forum Logo
