Rcdvt Posted May 6, 2021 Share Posted May 6, 2021 Went through heads. Valves gaskets everything. Re assembled..... Truck refuses to fire. Been constantly cracking and bleeding injector lines. Fuel pumping there. Injectors were all the done. New nozzles and pressure set. She acts like she wants to go but isn't quite there. Any suggestions? Quote Link to comment Share on other sites More sharing options...
Dirtymilkman Posted May 6, 2021 Share Posted May 6, 2021 Lots and lots of ether. Quote Link to comment Share on other sites More sharing options...
Hayseed Posted May 6, 2021 Share Posted May 6, 2021 What the Milkman Said... 1 Quote "Be who you are and say what you feel...Because those that matter...don't mind...And those that mind....don't matter." - Link to comment Share on other sites More sharing options...
mowerman Posted May 6, 2021 Share Posted May 6, 2021 blow air into the fuel tank...i have to do that quite a bit to start my DM....but i havent changed any of the worn out fuel lines yet....good luck...bob Quote Link to comment Share on other sites More sharing options...
Vladislav Posted May 6, 2021 Share Posted May 6, 2021 I would temporary install electric fuel pump into the fuel supply line or even attach a hose with such a pump and sunk into a jerrycan. Straight jumpering electric terminals takes all air and so from the primary circuit in less than half a minute. Than I would crank with the pump still on. If it's a matter of fuel supply or air the engine would start quite soon. If not your way is to investigate assembly mistakes. Such as injection timing, cam shaft timing, valves adjustment etc. Quote Никогда не бывает слишком много грузовиков! leversole 11.2012 Link to comment Share on other sites More sharing options...
h67st Posted May 10, 2021 Share Posted May 10, 2021 If you're getting fuel out of the lines when you pump the hand primer, then it's not a fuel issue. Quote Link to comment Share on other sites More sharing options...
JoeH Posted May 12, 2021 Share Posted May 12, 2021 Did you set the heads down on a table and smash the injector tips while you had the heads off? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.