markrandi Posted December 23, 2017 Share Posted December 23, 2017 How do u rplc front trans seal on mack 10 spd? Does the input shaft need to come apart? Quote Link to comment Share on other sites More sharing options...
j hancock Posted December 26, 2017 Share Posted December 26, 2017 Usually the shaft does not need to come out. What year is the truck and the trans. model? Mack Duplex? Fuller? T2100? 1 Quote JimIt doesn't cost anything to pay attention. Link to comment Share on other sites More sharing options...
terry Posted December 26, 2017 Share Posted December 26, 2017 The duplex, triplex and quad just had a reverse spirial on input shaft to push oil back, no lip seal. terry 1 Quote Link to comment Share on other sites More sharing options...
markrandi Posted December 27, 2017 Author Share Posted December 27, 2017 I took the input shaft out to replace the gasket. Anything special I should know before I put it back in? Quote Link to comment Share on other sites More sharing options...
terry Posted December 27, 2017 Share Posted December 27, 2017 Your going to have to give a little more info than that. terry Quote Link to comment Share on other sites More sharing options...
markrandi Posted December 31, 2017 Author Share Posted December 31, 2017 Mack tranny-10 spd. Looks like input shaft just slides in. Am I right or wrong? Quote Link to comment Share on other sites More sharing options...
theakerstwo Posted December 31, 2017 Share Posted December 31, 2017 He wants to know what model trans. Quote glenn akers Link to comment Share on other sites More sharing options...
Vladislav Posted December 31, 2017 Share Posted December 31, 2017 Mack had different models of transmissions during the years and about every generation had 10 speed model. The designs were different, and of the front shaft too. Quote Никогда не бывает слишком много грузовиков! leversole 11.2012 Link to comment Share on other sites More sharing options...
markrandi Posted January 1, 2018 Author Share Posted January 1, 2018 Will find out tomorrow when I go back to work. Quote Link to comment Share on other sites More sharing options...
markrandi Posted January 2, 2018 Author Share Posted January 2, 2018 Truck is a 2007 with a Maxitorque transmission. Quote Link to comment Share on other sites More sharing options...
markrandi Posted January 8, 2018 Author Share Posted January 8, 2018 On 1/2/2018 at 11:09 AM, markrandi said: Truck is a 2007 with a Maxitorque transmission. Quote Link to comment Share on other sites More sharing options...
terry Posted January 8, 2018 Share Posted January 8, 2018 They have a bunch of different maxitorque transmissions, have to have the numbers off of trans. to tell what you have. terry Quote Link to comment Share on other sites More sharing options...
kt_Engineer Posted January 11, 2018 Share Posted January 11, 2018 On 12/23/2017 at 3:27 PM, markrandi said: How do u rplc front trans seal on mack 10 spd? Does the input shaft need to come apart? You have either a T310, T310M, T310MLR or T310ME. The input shaft seal P/N is 88AX454/25632356. The seal can be installed without pulling the input shaft out. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.