markrandi
-
Posts
25 -
Joined
-
Last visited
Recent Profile Visitors
2,004 profile views
markrandi's Achievements
-
Ty. That's what I thought but Nextran keeps telling me it's just a button, spring & plate, nothing else. They can't find a contact on the computer. I've since gone to a different dealer in a different part of the state who said they ordered it. The horns work if I ground the wire that the spring contact goes to.
-
2006 mack granite city horn inoperable. All parts are present but can't figure out how the wire to the horn connects to contact plate on steering wheel.
-
Do u smell diesel fuel? COULD be cracked inj cups.
-
Where is the a/c hi spd relay/fuse located on a 2000 RD688S?
-
How do u remove #6 inj from an mbe 900 mercedes with the head on the engine in the truck?
-
Location of oil level sending unit on 2007 granite with an mp7?
-
TY, Sir! This is a single nut that has 2 small allen screws opposite each other that turn into a lock plate. I'm glad I asked. I was going to go 100-150 after pre-loading.
-
What are the torque specs for the drive axle wheel bearings on a ctp 713.
-
Where is the low air pressure sw located on a 2001 RD688S?
-
Using the rr main install tool on a 2007 MP7 how deep should the seal go?
-
-
What's involved in pulling the bellhousing off an 07 MP7 inframe?
-
Truck is a 2007 with a Maxitorque transmission.
-
Will find out tomorrow when I go back to work.
-
Mack tranny-10 spd. Looks like input shaft just slides in. Am I right or wrong?
BMT Forum Logo
