QCDriver

Photo shop look at the ground.

I was putting on a air leveling valve today and finally spotted roll pins. No wonder I could not find them, they are the size of a small, small finishing nail. The slipper pads looked as they would be pretty large (framing nail size). On a side note, way are these air ride valves failing. 2nd in year and half. Very clean air, no oil or water.?

Thanks rhasler. I guess I have to drill in hanger or maybe it's just painted over. No I have a striaght Meritor 10sp. I did not want to start this project till I had an idea of procedure. Thanks Agian.

No one can help?

Mack sells wiper arm assy. rebuild kits. The are a bitch with no room to work. But they have them. Not expensive either.

In the post "Air Ride broke", just ahead of his finger I need to replace the teflon pad. Mine does not have torx bolts to remove. Someone told me you have to drill and tap to get pins out. Could I just lift axle, and dump air, and place pad in? It's missing and is loud.

Where can I find your pics?

Has anyone bought one yet? I've got a call into Balt. Mack.

How do you replace the teflon pad for the Z spring?

Try standing Super Single. I feel your pain.

I had 11R 22.5 duals and switched to 455/50 22.5 singles and got an instant increase of .5 mpg. Could help some.

My in dash swithes are fully wired, nothing to crimp to for power...?

Would these be wired to the batt. and key rocker switch?

I had same sound last year, checked and greased driveline, 2k started all over,and kept on greasing. Well on day the u-joint exposed itself. Needles gone in 1 cap.

Always good parkimg. As soon as you get there after breakfast.

I'll be there sometime before 12. Thanks for update, boots in back of truck, and NO Spiked heels for my wife. Just look for a clueless guy with hot wife, in the 40's. Look for Flyer's cap.

That is one Sweet truck.. Oh and welcome to BMT also.

What is the condition of the field? Good or Muddy?

Nevermind

Has anyone converted a CH613 for the install of an R model hood? If so how much was involved? Thanks

I've used 2" tow straps with weather strip adhesive and glued to strap. Installed strap after glue cured. If you can't find them.

Look for a plate with 2 wires somewhere and screws on top of tank. Usually a universal sending unit should work.

Could someone please post the ride height for a CH613 with Meritor rears? Last six if needed 139664 I had it stored as a note in phone and forgot to save before a rom flash. Thanks

Yes it was a left side bearing. I've been chasing the noise for 4 months. I always thought it was left till right lug caps came off. Vibration from broken brake spring. At that time we used dial indicator on king pins and hub, all checked out per specs. Well the noise got louder last week and finally we got some noise and play spinning by hand. The outer bearing was wiped. Worse part you need the hub, as bearings cannot be bought per Mack and Meritor. I'm sure I could have had the number cross as they where a CR bearing. I thought there must have been a reason these style hubs should not rebuilt, they would have had a core charge. Thanks for all reply's Rear diff my need work.

Thanks I think I did something simular with bottle jack. It's off.