DM800guy
-
Posts
85 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
BMT Wiki
Collections
Store
Everything posted by DM800guy
-
Goodyear still makes them, look in jersey. Or yokahama makes a cheaper version if you wanna go new.
- 1 reply
-
- 1
-
-
Good Evening, If these parts are still avaliable pm me. Thank You
-
WTB: E6 Injection Pump Drive Shaft Housing & Front Timing Cover
DM800guy replied to mnslim's topic in Parts Wanted
Good Evening, Private message me may have a complete pump on a 237. -
What are you looking to get for this truck in a box.
-
Have one which is a diesel version.
-
1965 mack b61 with parts and r model hood cheap
DM800guy replied to Joe palka's topic in Trucks for Sale
Is this truck still for sale? -
You still looking?
-
The engine i have is 1979 235 with spin on filters. It's the later model. If you would like a picture of it PM me and i'll send it right over to you. As for the fuel curve gentleman. If the pump on the engine is set up for a six speed lo-hole which most of them were cause the 18 speeds went away in the early 70's to my knowledge but i could be wrong. The 18's and triplex's we are all talking about operate from 1500-2100. The lo-hole with the triple countershaft operates around 1200-1850. So the timing on the injection pump for the fuel delivery is different. Hence the term fuel curve.
-
I have a decent 237hp that would go right in there minimal mods and minimal rebuild. You need to do the injection pump over for the right fuel curve.
-
We have a single axle B-61LT project for sale with a pile of parts. Two cabs, two hoods, one set of fenders. One extra 9 speed overdrive transmission, also have a spare front and rear axle that goes with it. 20" spokes on the truck, and 22" spokes on the spare axles. Has a 235hp motor that goes with it and an extra radiator support. $3,500 takes all.
-
It's good for parts or if you wanna run it.
-
Is it still for sale?
-
Good Evening, I believe i have the passenger side panel your looking for. Let me know if you still need it.
-
Good Evening, Would a running 250hp work for you?
-
Good Evening, Are you still in need of rims?
-
I have a set of square diamond plate fuel tanks for sale, minor dents. Off of a 1954 b-61 tractor.
-
Good Evening, I have a few if you still them. Mario
-
Good Evening, If your still looking i have a set. Mario
-
B Model muffler heat shield
DM800guy replied to richard-b61's topic in Antique and Classic Mack Trucks General Discussion
Are you looking for the alummium muffer sheild? -
Do you still have the grille shell?
-
Yes the tank with the mounting brackets.
-
I have a complete 673p engine with an air starter that is working for sale. I will break it up.
-
You have a phone number you can be reached at.
-
DM-800 Dump Truck
DM800guy replied to j hancock's topic in Antique and Classic Mack Trucks General Discussion
Anybody know where there is some Dm800 parts sitting. Looking for fenders some 8 inch rims and a good green steering wheel. -
New York Macks 2
DM800guy replied to RFCDrum's topic in Antique and Classic Mack Trucks General Discussion
That was a glider built by Tony Capabaianco from Amityville
BMT Forum Logo
