880joe
-
Posts
542 -
Joined
-
Last visited
-
Days Won
1
Content Type
Profiles
Forums
Gallery
Events
Blogs
BMT Wiki
Collections
Store
Everything posted by 880joe
-
So are the axle spline different or can I use my existing axle
-
Thanks for checking and the information bbigrig -
Ok my last six of vin is 001873 pretty sure it's not 1 of the limited edition
-
Does anyone know if a crd 125 & 126 will fit in same housings as the 92 & 93.
-
Wouldn't an 01 just be a straight CH model I thought the CHN's came out in 05
-
Ok mine is a 613 but after looking closer at your stripes I believe mine are a little different. I'll post vin in a few days when I'm home and think of it. What year model is the limited edition
-
Is there an easy way to identify the CL Elite limited edition? I have 1 with the same paint scheme
-
Wasn't the early 1s etech and the latest 1s mp's
-
Heading says it's an AI 400
-
There is a topic here on this thread if you go back and do some digging
-
There's a thread on here about waking up those AI engines I think it's called Dead Dog Redemption on engine and transmission section it's probably a ways back. Not been much activity on it since the moderators on here seemed to of kicked the major contributors off the site.
- 1 reply
-
- 2
-
-
-
All you have to do is change the knob
-
My 99 CH's are only turn signals under the door I think that's the way on all of them
-
Tire/ Wheel interchange
880joe replied to phildirt's topic in Antique and Classic Mack Trucks General Discussion
A 17.5 wheel can be put in place of 15 inch it would be same situation as replacing 20 inch rims with 22.5's -
Anthem hood on a cxu613 ?
880joe replied to SinCityTowingandTransport's topic in Modern Mack Truck General Discussion
Did they change the hood on the Pinnacle or just the grill? -
Look on top of filter housing not sure if that's where it's at on an AC engine but that's where it's located on earlier etechs
-
Did you check the water level sensor
-
I believe I know what you're talking about on the firewall. Been driving these CH's for over 20 years first time I've needed to work on that part of truck
-
Thanks V I'll have a look and see if I can find it
-
Where is the tractor protection valve at on a 99 CH mack?
-
Which engine would be compatible with a 2006 CHN613
880joe replied to Dannielle's topic in Engine and Transmission
I believe you are going to need to stay with the AC engine or have to do a lot of modifications to make something else work. What is wrong with the engine you now have? -
Guess I lost your email address could you pm me again with it I took some photos today
-
Yes I got it I've just not had time to get pictures
-
2002 Mack Ch 427 6-4 codes Help
880joe replied to Jomorisn's topic in Electrical, Electronics and Lighting
I believe the 6-4 code means the ecm is not communicating with the vecm -
2002 Mack Ch 427 6-4 codes Help
880joe replied to Jomorisn's topic in Electrical, Electronics and Lighting
I just had to replace the engine ecm on my 99 CH if I remember correctly it gave a 6-4 code. It acted up 1 day then ran fine for a week or so then went to leave 1 day it started and died immediately then never ran until I changed ecm.
BMT Forum Logo
