Jump to content

460 aset no start


SLEDOG

Recommended Posts

ok... now..... you opened the fuel lines at the head and bled off at least 2, right,  like 'F' said, you pump the primer and pull on the line a little bit and bleed the air..   jojo

Link to comment
Share on other sites

1 minute ago, Joey Mack said:

ok... now..... you opened the fuel lines at the head and bled off at least 2, right,  like 'F' said, you pump the primer and pull on the line a little bit and bleed the air..   jojo

I tried but I couldn’t break the line’s loose... I need to go back at it tomorrow with I propane torch and get them loosened up....we deal with rust here...

Link to comment
Share on other sites

I know... I'm from Maine...  road salt kills everything..  may I suggest you spray them now with PB Blaster, and let them soak over night...  any good pen. oil will do, then tomorrow use a 3/4" wrench and work them back and forth, with care... the lines are about $150.00 ea.  only need to bleed 2 of them... pick 2 easy ones.  ie: 2+5.....  jojo

Link to comment
Share on other sites

yes sir..... I believe it is a fuel delivery issue, and you make good sense..  I hope he doesnt load the parts cannon and fire it,  however,, he seems to be diagnosing instead... jojo

Link to comment
Share on other sites

good call Onyx,  Ive been in N.C. for 16 years, and I rarely ever need to pull out torches, and such,  plus a million curse words..  I still anti-sieze every bolt that needs it...  :) .. jojo

  • Like 1
  • Haha 1
Link to comment
Share on other sites

10 hours ago, SLEDOG said:

Yah this truck hauled road salt for a bunch of seasons too so the rust has really gotten to her..

usually end up cutting and grinding bolts just to get parts off all the time...O joy!

Pry a double frame too!

Link to comment
Share on other sites

22 hours ago, fjh said:

There is a fuel galley plug just above where the blow by can bolts it can be accessed by removing the lid! 3 inch 1/4 pipe close nipple and an elbow! to screw a gauge into! 

Yah I’m going to see if I can figure out what tj was describing here and try to puta gauge in there so I don’t have to take the fuel temp sensor out again ....

Link to comment
Share on other sites

20 hours ago, Joey Mack said:

I know... I'm from Maine...  road salt kills everything..  may I suggest you spray them now with PB Blaster, and let them soak over night...  any good pen. oil will do, then tomorrow use a 3/4" wrench and work them back and forth, with care... the lines are about $150.00 ea.  only need to bleed 2 of them... pick 2 easy ones.  ie: 2+5.....  jojo

Thanks Joey..... I actually had to crack 4 lines....she just didn’t want to go on two....

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...