Door window weatherstripping

[Quickfarms]

I have to replace the drivers door on my 1975 RS685LT and I need to replace all of the weather striping, etc for both the vent window and roll up window.

 

What is a good source and part numbers?

[Coenut]

Restoration specialties has all of that.  Even some with the stainless bead. They are fantastic and will send you samples to verify for before you buy lengths. I used them for the doors on my r model. I have a set of workers that I bought from watts of you need.

[kscarbel2]

On 5/5/2020 at 5:43 PM, Quickfarms said:

I have to replace the drivers door on my 1975 RS685LT and I need to replace all of the weather striping, etc for both the vent window and roll up window.

What is a good source and part numbers?

For both doors, you need 4 pieces of Mack part number 440SX30A.

The 440SX30A is for the tracks on the removeable door panel, and the upper section of the door (you'll need to cut/shorten that upper piece).

You only use the included brass retaining clips on the removeable door panel tracks.

The vent window post felt is different, and is (was) sold under a vendor number 2795-170014005 (1 per vent window).

The roll-up window "wipers" are Mack part numbers 35RU223 and 35RU224 (2 each).

[Quickfarms]

Is the rubber around the vent widow available?

if it is what is the source and part number 

[mowerman]

That would be wonderful I don’t need any but it’s nice to know a regular glass shop will have the felt for the bottom and top the rubber may be a little issue good luck.. bob