Hook n ladder 1 Posted January 17, 2020 Share Posted January 17, 2020 My oil pan is rotting and starting to leak oil. It's a 98 Ch613 with an E7-427 (reman engine installed in 2008). Once I get the pan and gasket kit is there any tricks I should know about or is it unbolt old one clean the surfaces and install the new one? Thanks in advance. Quote Link to comment Share on other sites More sharing options...
davehummell Posted January 17, 2020 Share Posted January 17, 2020 Glue the gasket to the pan with contact cement I just payed 84.00 for a pan gasket so you don't want to buy two of them. Quote Link to comment Share on other sites More sharing options...
theakerstwo Posted January 17, 2020 Share Posted January 17, 2020 Dab a small amount of slicone at the cover to block joint and same at the rear. Quote glenn akers Link to comment Share on other sites More sharing options...
Hook n ladder 1 Posted January 17, 2020 Author Share Posted January 17, 2020 What kind of silicone and or contact cement? Like a Permatex type product? Quote Link to comment Share on other sites More sharing options...
fjh Posted January 17, 2020 Share Posted January 17, 2020 If its a silcone gasket do none of the above except clean! if its a paper one do as prescribed~ Quote Link to comment Share on other sites More sharing options...
Hook n ladder 1 Posted January 17, 2020 Author Share Posted January 17, 2020 ok thanks Quote Link to comment Share on other sites More sharing options...
Hook n ladder 1 Posted January 20, 2020 Author Share Posted January 20, 2020 How much difficulty am i going to have getting the old bolts out? Should I put new bolts in it or do can I get a bolt kit for it? I had a nightmare last night of breaking the bolts off. Should I Lock-Tite the new bolts? Quote Link to comment Share on other sites More sharing options...
alex g Posted January 20, 2020 Share Posted January 20, 2020 All my bolts came out 2000 CH. Some near front were a bit difficult I think I used a swivel and extension but it wasn't a bad job. I reused bolts Quote Link to comment Share on other sites More sharing options...
fjh Posted January 20, 2020 Share Posted January 20, 2020 2 hours ago, Hook n ladder 1 said: How much difficulty am i going to have getting the old bolts out? Should I put new bolts in it or do can I get a bolt kit for it? I had a nightmare last night of breaking the bolts off. Should I Lock-Tite the new bolts? NO DO NOT Lock tight the bolts ! if you want put a dab of silicone on the threads locktight is too viscous! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.