880joe Posted May 21, 2016 Share Posted May 21, 2016 Just wondering if they ever put a series 60 in any CL or CH macks Quote Link to comment Share on other sites More sharing options...
0 brenner Posted May 21, 2016 Share Posted May 21, 2016 They put them in the CL around the same time they put Cats in them Quote Link to comment Share on other sites More sharing options...
0 bbigrig Posted May 30, 2016 Share Posted May 30, 2016 (edited) On 20 mai 2016 at 10:54 PM, 880joe said: Just wondering if they ever put a series 60 in any CL or CH macks Yes, it was available for about 3 years as an option from factory on CL's from 1993 to 1996. It was an expensive option and was known as a CL643/743. I was lucky to see a total of 7 of them here in Canada over the 3 years they were available. Very well suited in the trucks. The CH rails were to tight for a 60 series. The Cat option was available until 1999 on the CL's. There was no Cummins option in the CL until the ISX in 2002. Edited May 30, 2016 by bbigrig 2 Quote Link to comment Share on other sites More sharing options...
0 BOB DINGSDALE Posted May 30, 2016 Share Posted May 30, 2016 nice to see another B C er on here Quote Link to comment Share on other sites More sharing options...
0 880joe Posted May 31, 2016 Author Share Posted May 31, 2016 Would any one on here have a vin # from a detroit powered cl . Would a detroit be very much bigger than an E7 they looked close to same size to me Quote Link to comment Share on other sites More sharing options...
0 kscarbel2 Posted May 31, 2016 Share Posted May 31, 2016 1 hour ago, 880joe said: Would any one here have a vin # from a Detroit-powered CL? Would a Detroit be very much bigger than an E7? They looked close to same size to me. The Series 60 in the CL643s was a good bit bigger than the E7. Quote Link to comment Share on other sites More sharing options...
0 bbigrig Posted June 2, 2016 Share Posted June 2, 2016 Both the 11 and 12 liter Detroits were Taller, wider and longer then an E7. E7 was one smallest engines on the market putting out more then 410hp for most of the 90's. Quote Link to comment Share on other sites More sharing options...
0 bbigrig Posted June 2, 2016 Share Posted June 2, 2016 The only Vendor engine I've ever heard of being put in a CH was 5 trucks built for Consolidated Freightways in the early 90's. The were Cummins L10Celect or M11 engines. They existed on the Mack parts system still a few years ago under the CH633 prefix. Quote Link to comment Share on other sites More sharing options...
Question
880joe
Just wondering if they ever put a series 60 in any CL or CH macks
Link to comment
Share on other sites
7 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.