Nothing works after changing batteries

[Dustdee]

I changed batteries on 2010 CXU 613 and now nothing works. Does anyone have a diagram or photo of how the three batteries cables should look? There is correct voltage to everything. No lights work either. Everything was normal before changing the batteries except they were dead and wouldn't wouldn't jump.

[mrsmackpaul]

When you say you have the correct voltage 

Were are you measuring the voltages at ?

 

Paul 

[Joey Mack]

Check the fusable link on the neg side.. connect a jumper cable from batt. neg. to the frame and retest

[Dustdee]

16 hours ago, mrsmackpaul said:

When you say you have the correct voltage 

Were are you measuring the voltages at ?

 

Paul 

At each battery and down the line past the disconnect inline fuse and the fuse box. Also the ignition

[mechohaulic]

16 hours ago, Joey Mack said:

Check the fusable link on the neg side.. connect a jumper cable from batt. neg. to the frame and retest

I'm guessing this is 3 -12volt connected parallel ?  right track Jojo 'bad connect on neg chassis cable .