Mark Kilroy Posted August 18, 2013 Share Posted August 18, 2013 Hi guys how'sit going? I recently bought an old rd with a reman E7 300 and it's a great truck. But sometimes after running it on the highway for awhile when it comes time to exit and the truck slows down it will stall unless you keep you foot on the peddle or if it doesn't stall it will idle rough for a few minutes. does anyone have any ideas Quote Link to comment Share on other sites More sharing options...
masterwelder Posted August 18, 2013 Share Posted August 18, 2013 Mine was close to doing the same thing. I just set the idle up a little and it took care of it. Quote Link to comment Share on other sites More sharing options...
hatcity Posted August 18, 2013 Share Posted August 18, 2013 What is your oil pressure at the time?May need an oil change, or pressure sensor is bad, or do what Sivart said Quote Success is only a stones throw away.................................................................for a Palestinian Link to comment Share on other sites More sharing options...
amakaris Posted August 19, 2013 Share Posted August 19, 2013 I have the same thing happen with a Mechanical 7-350. Drive on the highway, get off the exit and it stalls out. The oil pressure drops considerably. Maybe it's the filters??? Or needing an oil change? What oil should I be using to avoid this? Quote Link to comment Share on other sites More sharing options...
theakerstwo Posted August 21, 2013 Share Posted August 21, 2013 I would be for checking the fuel pressure.Check it at the inlet of the pump housing were the line goes in to the injection pump. You will have to make your self a tee and you want about 30 psi. If is too low it will want to die when its running slow. Quote glenn akers Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.