Johnny B Posted September 26, 2006 Share Posted September 26, 2006 Hi, folks-- I'm new to the board... The company I work for is getting around to scrapping some old mid-80's Midliners. Before they go, I'd like to salvage the Bulldog ornaments off the noses. The heads of the bolts that secure the dogs' hind paws look like two opposing triangles. Is there a special bit or driver that is required to remove these bolts? What is it called? Thanks for any advice. Quote Link to comment Share on other sites More sharing options...
woberlin Posted September 26, 2006 Share Posted September 26, 2006 It sounds like a clutch head screw. Most bit sets have one in them, or can be bought at sears or most any hardware store with a gook tool selection. You may want to spray them with some penetrating oil before you attempt removing them. Good luck! Quote Link to comment Share on other sites More sharing options...
fullfuel01 Posted September 27, 2006 Share Posted September 27, 2006 the only tool that ca remove that dog is vice-grip.... Quote Link to comment Share on other sites More sharing options...
de37champ Posted September 27, 2006 Share Posted September 27, 2006 -->QUOTE(Johnny B @ Sep 26 2006, 09:30 AM) ←Hi, folks-- I'm new to the board... The company I work for is getting around to scrapping some old mid-80's Midliners. Before they go, I'd like to salvage the Bulldog ornaments off the noses. The heads of the bolts that secure the dogs' hind paws look like two opposing triangles. Is there a special bit or driver that is required to remove these bolts? What is it called? Thanks for any advice. After working at it for a hr with busted nuckels and broken bits and drill bits i used a sawsaw, but it looks good hanging on the wall Quote Link to comment Share on other sites More sharing options...
rick harper Posted September 27, 2006 Share Posted September 27, 2006 those screws part number 103AX105 are anti theft screws. will have to cut them off or find a BFS to catch the screw and back them out. Quote Link to comment Share on other sites More sharing options...
David Posted September 28, 2006 Share Posted September 28, 2006 You might be able to cut a slot with a thin disc on a die grinder and then remove with a large flat screwdriver. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.