Jump to content

Need help with ENDT676 sleeve


Triggerhappy

Recommended Posts

I'm working on an ENDT676, engine was out of framed a year ago. It developed a cracked head so we pulled it apart to fix. Found 2 sleeves that can be moved by hand. The question I have is, are the sleeves supposed to be interference fit, or how tight should they be? The block was cut for .010 over sleeves, 4 of them are tight but two move. Azny help would bed appreciated. Have had no luck so far finding what the block bore should be compared to the sleeve outer diameter.

 

Thanks!

Link to comment
Share on other sites

9 hours ago, turckster said:

The spec for liner fit in the bore is .002" loose to .001" tight. Liners moving while rotating the engine is nothing to worry about. If they do move, make sure no debris or crud gets under the liner flange. 

If you are concerned clean and dri the bore , I have put a small amount of lock tight at the very bottom of the bore  however I also  would not be too concerned  as stated  00,2 is still ok don't forget the liner will likely swell as the engine warms  , It ran before it will run again! 

Just sayin!

  • Like 2
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...