Jump to content

Water pump for thermodyne


Tony Ingram

Recommended Posts

should be the same an any 6 cylinder diesel Mack. they only made two or three of them back then and the only differences are the length of the shaft and sometimes the clockin where it bolts to the oil cooler. think an 237 water pump should fit most thermodyne's. may have to use your old spacer blocks for the oil cooler tho.

post-6-0-64947600-1408238925_thumb.jpg

Link to comment
Share on other sites

should be the same an any 6 cylinder diesel Mack. they only made two or three of them back then and the only differences are the length of the shaft and sometimes the clockin where it bolts to the oil cooler. think an 237 water pump should fit most thermodyne's. may have to use your old spacer blocks for the oil cooler tho.

If that has the original engine in it you'd' be pretty hard pressed to find either an oil cooler or a thermostat housing on it!

But as stated above maybe you could find a newer one with same shaft length and change the pulley.

There is a company in New York state that rebuilds water pumps for antiques, I'm not sure if they do heavy duty or not but it might be worth a shot if all else fails.

Ron

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...