cgallamore Posted September 30, 2012 Share Posted September 30, 2012 The nut came loose. On the actuatorI'm using a hammer and chisel (spanner nut)How tight should this nut be, I don't have a clue???? Quote http://www.bigmacktrucks.com/uploads/1272400769/gallery_4852_794_314995.jpg Link to comment Share on other sites More sharing options...
staxx Posted October 1, 2012 Share Posted October 1, 2012 Tight enough it wont come loose again 1 Quote Link to comment Share on other sites More sharing options...
theakerstwo Posted October 1, 2012 Share Posted October 1, 2012 now there is some good sound advice. Quote glenn akers Link to comment Share on other sites More sharing options...
Lmackattack Posted October 1, 2012 Share Posted October 1, 2012 I 3rd the motion... Quote Link to comment Share on other sites More sharing options...
staxx Posted October 1, 2012 Share Posted October 1, 2012 The last one I replaced I had to cut the nut/actuator off to remove they usally seize on there dont have the torque spec handy rite now can get them later this week if needed but two or three good smacks with hammer chisel should do. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.