SLEDOG
-
Posts
116 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
BMT Wiki
Collections
Store
Everything posted by SLEDOG
-
Well I’ve had some good luck fixing my 07 granite on this site so here I go again… Blower works great but not much at defroster vents when called for. im taking console apart now and was wondering if there is a flapper or something that I need to check and how do I get to it…. Thanks Sledog
-
I think we got it now guys! Been driving for four hours now with no hiccups. Starts better too. When truck was in shop for broken bell housing they found bad stud on starter so they replaced starter. After that they could not start truck. They changed 135 amp ground breaker. They also left ground wire to frame and motor disconnected and ran there own ground from battery to frame and cab. I put everything back to original per prints. Thanks to all who helped, and a special thanks to Joey Mack! I know you told me to check grounds in the beginning.
-
I just got done taking grounds of and checking. Found a couple issues and wired grounds the way they are supposed to be. She starts fine and I need to work her and see what happens now I think.
-
Which relay in glove box will cause me an issue with this… there’s 6 or seven in glove box
-
Still chasing original post I put new crank sensor in and I haven’t actually worked the truck to test yet. it does stall when cam sensor pulled and I’m led to believe it should not do that…. sledog
-
Tjh yah I didn’t see this post until after I put my foot in my mouth…. dog
-
Joey I understand what you are saying. I’ll have to see if my neighbor has that socket for the tranny and if I can borrow it …. Sledog
-
Joey I didn’t see your post until just now on the locating pin on the flywheel. They couldn’t have got that wrong then ….. sledog
-
Joey They must have had the flywheel off because I had them put a new main seal on while they were in there since old one was leaking. so you are saying the flywheel was not indexed when they re-installed it possibly? This may be an issue I have to take up with shop then…. If it does need indexing I’ll call the shop and see if they actually did that or not. I don’t have that special socket to bar it over anyway… sledog
-
Wow that’s a lot…so the ring gear might be on the flywheel wrong? Or slipped? how do I know where the 45 degree mark is?
-
Aftermarket bell housing same flywheel …I had a Local shop work on it
-
The new was around 800 ohms…
-
I don’t if that sensor was good or bad when the housing broke…
-
No it was starting to have a fish-bite miss before….
-
Joey…Ok put new sensor in and still shuts down when I pull cam sensor…. is there a way to see if new sensor is picking up teeth on flywheel ? and I recently had new aftermarket flywheel housing installed ( Mack had part on Bo).looking in the hole the teeth only cover half …is that ok? I have 2mm clearance between teeth and end of sensor
-
Joey the first couple feet look good to where it goes into big loom by the engine sledog
-
Joey im only getting about 4 ohms on sensor. sledog
-
Is there a way to test sensor with ohm meter?
-
No I’m not getting any codes for that
-
Joey yah motor shut off when I disconnected cam sensor. looking to get a new one for bell housing now thanks a million!! sledog
-
Joey Ok thanks I’ll try that tomorrow morning. sledog
-
Joey Not sure I totally understand sensor test. Are you saying it should stay running when I unplug one at a time? And if it does they are both good? sledog
-
I never get a guage and actually check pressure Onyx
-
Yes it is onyx
-
Ok what pressure should I see?
BMT Forum Logo
