felicello122

Hey fifth wheel can you still Get the floor mats for the 300 series, i need one for my restoration im getting ready to start on a k361 318 detroit

85 should have square head lights

Ck the small fuel return line for leaks from rubbing or chafing

I no they fit in a r model, but do you think they would fit the rd hood

Nice pics

Put air ride seats. In the bed

Looks way Better outside the cowl, not sure about a factory option, i would do it anyway, a nice chrome one

You have to push in the clutch to see the fitting

Toyota gave out new frames and free replacement my freind had his done

Nice work Timmyb

How much are the military seats

Thanks for posting. I have been looking at the original post for updates. I'm glad you have updated your progress. I'm a great lover of the F model, I'm in Australia and their are a couple of F models for sale at the moment, but I'm not in a position to move on them. One is in Western Australian, restored. No mention of what box or engine. Looks ok. Another in Victoria with and E9 unrestored. I would prefer one with an sleeper cab with an E9 and a maxitorque with 44's at the back.

I changed a few in mine, never flashed none of them, truck runs great been years,it does say to flashed them.

Richard i forgot to measure for you, have to do it friday when i go back to work

What year is that rw looks nice, your doing an excellent job

That sucker is white!

Some pics from today.

Gallicchio

Image12142014094125.jpgImage12142014150315.jpg

Superliner looking good.

Image12142014074550.jpg

On the back of the pump where the air line hooks up there is a small diaphragm in there that go bad, its the pollution device ck it, unhook the airline 5/8 wrench and remove the 4 screws to remove the cover,you will see the diaphragm remove the center screw and ck for a hole or tear.

I have a stainless one off a r model looks very close to your dimensions i can give it a quick measurement tomorrow. If you like, you may be able to use your brackets, i do not have them

No on that leversole,the bearings are bigger and the seal is different

Excellent

Change only the tire and rim, they will fit 10-20 hubs Quickfarms

11-22.5 to 10-20. 11-24.5 to 10-22

Get yourself a nut insert tool,puts a 1/4 blind nut in the cab then you thread the bolt in tight, napa sells the kit is fairly cheap, as for the lights you can do the same thing and feed the lights to that one wire with 1 wire running across.when you do the visor lay it on the cab and mark your holes and drill,same for lights

Should be marked underneath under the little square plate on the bottom of the flywheel housing.turn it over if you have the tool till you reach 1and 6 on the markings, i pop the the front valve cover off and you should be able to move the rockers. On the inlet and exhaust valves,,if they are tight you have to turn it over one more time around untill you get to 1 and 6 again that will be TDC on hole 1

Ok