bubbamobilin Posted April 3 Share Posted April 3 I have a 1997 E7454 that just had the injection pump, injectors and econovance rebuilt. At any rpm while driving it will stumble like the engine had been switched off. Doesn't seem to do it when you're 100% on the accelerator pedal. Also, the cruise control will not work while driving. It will let you idle it up while sitting still. Where should I start looking? Quote Link to comment Share on other sites More sharing options...
Joey Mack Posted April 3 Share Posted April 3 Was it doing this before the pump and nozzles ? Quote Link to comment Share on other sites More sharing options...
bubbamobilin Posted April 3 Author Share Posted April 3 Joey Mack yes it was Quote Link to comment Share on other sites More sharing options...
Joey Mack Posted April 3 Share Posted April 3 Does it have engine brakes ? Quote Link to comment Share on other sites More sharing options...
Joey Mack Posted April 3 Share Posted April 3 Just wondering if you have a sticky engine brake celenoid or plunger 1 Quote Link to comment Share on other sites More sharing options...
Joey Mack Posted April 3 Share Posted April 3 i assume V-Mac II. cruise is attached to the clutch switch just like the engine brake, I guess I am assuming engine brake here.. how is the condition of the wire harness at the injection pump, on the engine side of the harness? loose pins and of course frayed wires can cause this.. if the duetch connector is not secured in its yoke, it will shake and loosen up. Pictures always help when we try to guide someone to the repair.. jojo 1 Quote Link to comment Share on other sites More sharing options...
bubbamobilin Posted April 4 Author Share Posted April 4 23 hours ago, Joey Mack said: i assume V-Mac II. cruise is attached to the clutch switch just like the engine brake, I guess I am assuming engine brake here.. how is the condition of the wire harness at the injection pump, on the engine side of the harness? loose pins and of course frayed wires can cause this.. if the duetch connector is not secured in its yoke, it will shake and loosen up. Pictures always help when we try to guide someone to the repair.. jojo Yes it has an engine brake. We did the complete wiring harness about 5 or 6 years ago but you know that doesn't mean anything. Would a bad accelerator pedal cause the cruise to not work? I'm about convinced that where the stumble is coming from. If you are on the pedal 100% it won't do it. Only falls out when your in the middle somewhere. Quote Link to comment Share on other sites More sharing options...
Joey Mack Posted April 4 Share Posted April 4 yep,, now your getting closer. do you have another truck that you can swap pedals with.. it may have a dead spot where you may normally cruise at... in the TPS... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.