Jock Posted April 18, 2016 Share Posted April 18, 2016 I have restored a 1982 built R600 320hp Coolpower truck with a 10 speed box I am keen to see the correct rev range to change gears - correct clutch procedure both up and down shifts - The transmission is a D1070 i can send photos can anyone shed some light please ? I also wonder if the cab airbag is meant to be adjusted or has a correct setting ? -( mine seems rock hard ) Thankyou ,Jock Quote Link to comment Share on other sites More sharing options...
0 j hancock Posted April 19, 2016 Share Posted April 19, 2016 Page 40 on the link will have some info. http://smrp-prod.macktrucks.com/spubs/internet/pdform/ts453.pdf Thinking there is about 300-350 rpm between gears. Send pictures of truck, trucks, sheilas, etc... Quote JimIt doesn't cost anything to pay attention. Link to comment Share on other sites More sharing options...
0 Jock Posted May 24, 2016 Author Share Posted May 24, 2016 Thankyou Jim I will have a look over the great manual you have forwarded so that i can work out the best rev range , I have been out of range for a while - I have been doing a few loads and the gear shifting has been improving (too slowly) Plenty more photos available inside and out . Thankyou Jock 1 Quote Link to comment Share on other sites More sharing options...
Question
Jock
I have restored a 1982 built R600 320hp Coolpower truck with a 10 speed box
I am keen to see the correct rev range to change gears - correct clutch procedure both up and down shifts -
The transmission is a D1070
i can send photos
can anyone shed some light please ?
I also wonder if the cab airbag is meant to be adjusted or has a correct setting ? -( mine seems rock hard )
Thankyou ,Jock
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.