Mecanical E7-350 oil pressure sensor location?

[Nightwolf769]

Can anyone positively tell me where the oil pressure sensor is on a mechanical E7-350? It is not on top of the oil filter housing like some people say it is.

[Mackpro]

Follow the plastic or braded line on top of the filter stand to the firewall. It should go to the bulkhead pass through on the fire wall. Take note of were it goes in at, then look inside the cab and fine where it comes through. The sensor should be on a "Tee" where the line comes through or on the bulkhead pass through above or below where the line comes through.

[emma_akc]

Pls how many liters of engine oil can the 2006 Mack vision cxn 613 E7 take when changing the engine oil

Sent from my iPhone using Tapatalk

[turckster]

Can anyone positively tell me where the oil pressure sensor is on a mechanical E7-350? It is not on top of the oil filter housing like some people say it is.

On the mechanical engine the oil psi gauge is a mechanical gauge. There should be a #4 stratoflex line from the oil filter base through the cab to the gauge. It may run into a block located behind the speedo/tach for the kysor alarmstat sender then from there to the gauge.

[turckster]

Pls how many liters of engine oil can the 2006 Mack vision cxn 613 E7 take when changing the engine oil

Sent from my iPhone using Tapatalk

Depends on the type of oil pan you have. On the regular pan the system total capacity is 10 gallons/40 qts (38L)--filters and oil pan. The deep pan system total capacity is 14 gallons/56 qts (53L).