Junior9009
-
Posts
70 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
BMT Wiki
Collections
Store
Everything posted by Junior9009
-
Searching for a chrome or stainless air intake hat for an R model. TIA
-
Looking for a factory R model exhaust heat shield. Truck doesn't have a vertical exhaust just straight pipe. TIA
-
Looking for a pair of aluminum fuel tanks for my 89 R model. If anyone has any they'd like to sell please let me know. Even if it's only one. Thanks
-
I would like to install full stainless fenders on my R model tandem axle tractor. It has the Reyco spring ride suspension from factory. The equalizer is located where I would have to put the center support for the fender. Looking for anyone with advise as how to mount this bracket or anyone that has installed full fenders on a truck with Reyco suspension. Thanks.
-
I was doing some work on my 89 R model today and realized my rear cab airbags aren't solid. Made sure I had enough air in the tanks but quickly ruled that out. The one on the left had a small leak at the base but they should still hold air correct?
-
Door will not latch closed!
Junior9009 replied to blue rd's topic in Exterior, Cab, Accessories and Detailing
Off topic but I bought hood latches and exterior door handles from PAI off eBay and am having problems with the hood latches staying closed. The latch handle doesn't close enough when latched and they pop open. My old steel latches did the same thing so the hook that bolts to the hood with the 4 bolts may be the problem. -
Looking for a factory exhaust heat shield for an R model. My truck no longer has the muffler on the up pipe so I would probably need the skinnier one. Thanks.
-
Looking for aluminum intercooler pipes for an E6 350 engine in an R model
-
Hi all. I'm looking to install the 4-rib stainless life time fenders on my tandem axle R model. It has the reyco spring ride suspension and the equalizer is located in the center of the axles right where the center support would bolt to the frame for the fender. I was wondering if anyone has installed full fenders on a truck that has this suspension so I know if I can install on mine. Pics would be greatly appreciated as well. Thanks, Greg
-
Looking to buy new intercooler boots and chrome intercooler piping for an E6 -350.
-
Looking to buy a pair of 55-gal polished aluminum fuel tanks for my 89 R688ST.
-
If I pull it up in 4th gear it makes a strange howling noise for a second. If i pull it up in 4th and don't use the clutch it sounds like its slipping and my RPM's fall all the way down as if its in neutral. So I take it out of gear and then pull up on the range selector while the stick is in neutral then it falls right into 5th.
-
Bought new chrome door handles and hood latches for my truck. The door handles were an "OK" fit but the hood latches don't want to stat latched. Almost seems as though they don't slide down far enough on the hood clamp bracket. Anyone else have an issue with these?
-
Will do thanks Jim!
-
Looking for any type of service books for my 89 R688ST. Engine is an E6 350, 9-spd maxitorque (T2090) trans, Reyco suspension Mack 38k rears. Also electrical books/schematics.
-
Looking for the silicone boot that connects the piping together. Should be 4 total.
-
Been having a problem with the trans in my truck not going back into the low side properly when the selector is pushed down. It usually doesn't go in until you go to pull out again as you ease off the clutch. I even have to move the shifter out of gear before I pull the selector up or it has a hard time going into gear when upshifting. Any clue as to what could be going on? Truck has Truck/driveline has 340k on it.
-
Want to replace the intercooler boots on my 89 r model with new. Anyone have a set for sale? Thanks
-
Aluminum wheel restoration
Junior9009 replied to ranchhopper's topic in Exterior, Cab, Accessories and Detailing
How many pieces were in your kit ranch hopper? -
Dual air cleaner tubes for R model
Junior9009 replied to Junior9009's topic in Exterior, Cab, Accessories and Detailing
He found a set. My apologies for not getting back to you sooner. -
Looking for a set of new chrome door handles and hood latches for an 89 R model or some ideas of who sells them. Thanks!
-
Fuel gauge/tachometer
Junior9009 replied to Junior9009's topic in Electrical, Electronics and Lighting
My tach is electronic. I was messing with the telescopic steering wheel the other day and everytime I would push the column towards the dash with the truck idling the tach would drop out and come back. I imagine I have a short somewhere? -
R model full fenders
Junior9009 replied to Junior9009's topic in Exterior, Cab, Accessories and Detailing
I worry about articulation on mine as well. I have Reyco spring ride on my tractor. Wouldn't want the getting torn off. However mine stays in the highway. -
The fuel gauge in my 89 R model doesn't work. It's always showing empty. Also my tach will drop out from time to time then come back. Where is a good place to start looking? Where is the ground for both of these?
-
Looking for the interior panel that goes on the cab behind the drivers seat for an 89 R model. I imagine it's one big piece that runs side to side. Color is a dark grey/charcoal. Thanks!
BMT Forum Logo
