cxn613 Posted November 2, 2021 Share Posted November 2, 2021 In the process of installing a new clutch and rear main seal. With that being said, I have oil residue around the flywheel housing. Is there any suprises to removing it to reseal? Looks like remove oil pan, support rear of engine, remove starter and rear motor mounts and then remove housing? Does it seal with a gasket or gasket maker? Thanks in advance Quote Link to comment Share on other sites More sharing options...
cxn613 Posted November 2, 2021 Author Share Posted November 2, 2021 Sorry, did not specify truck, this is on a 2008 cxu613, mp8, 13 speed eaton. Quote Link to comment Share on other sites More sharing options...
Vmac3 Posted November 3, 2021 Share Posted November 3, 2021 The housing is resealed with silicone. Dont forget to make sure that the upper timing cover is flat with the cylinder head when you reinstall it. Otherwise you will create another oil leak. As for the job, it is pretty straight forward. V Quote Link to comment Share on other sites More sharing options...
cxn613 Posted November 3, 2021 Author Share Posted November 3, 2021 Ok. Thanks for the reply. Quote Link to comment Share on other sites More sharing options...
Vmac3 Posted November 3, 2021 Share Posted November 3, 2021 3 hours ago, cxn613 said: Ok. Thanks for the reply. No worries. V Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.