Mackksa Posted November 13, 2018 Share Posted November 13, 2018 I have a mack truck mru with mp7 engine in workshop, eecu is not being detected by the computer (vcads). and engine is also not cranking. checked all the fuses all ok. engine is only cranking if giving power directly on the starter but not starting,. need help and advise Quote Link to comment Share on other sites More sharing options...
fjh Posted November 13, 2018 Share Posted November 13, 2018 If it is a Garbage truck Start by looking for Rat chewed wiring! Also check your ecu plugs for oil or coolant contamination ! Quote Link to comment Share on other sites More sharing options...
Mackksa Posted November 13, 2018 Author Share Posted November 13, 2018 it is a garbage truck. it was starting well only few hours earlier. and after few hours we tried to start again, it did not crank. ecu plugs are ok, no contamination. checked with the computer but it is not communicating with eecu. Quote Link to comment Share on other sites More sharing options...
turckster Posted November 18, 2018 Share Posted November 18, 2018 Check voltages and grounds at the eecu. On the left side of the radiator there is a cab to chassis harness connector. I have seen where the bolt connecting the two together have come loose or some pins having corrosion. Quote Link to comment Share on other sites More sharing options...
Mackksa Posted November 22, 2018 Author Share Posted November 22, 2018 Ok thanks shall check that Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.