Jump to content

Quadbox teardown


skip
 Share

Recommended Posts

Gday Everyone.

I have a quad box that is jumping out of 1st gear and I want to pull it apart and fix it up.

Has anyone pulled one apart before?

Is there anything I should be careful of? ie. Is there anything that is normally damaged/discarded like a bearing or different retainers?

Ive got a Mack manual that gives basic instructions and thats it.

Any suggestions or input woulod be appreciated.

Thanks and Regards,

Skip

Link to comment
Share on other sites

Don't miss the oil pump plunger in the input shaft and also remember to adjust the end play in the lower counter shafts. The rear yoke nut is very tight and its been 35 years since I have worked one but sounds like the torque is around 600 lb

glenn akers

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...