meca Posted October 27, 2012 Share Posted October 27, 2012 Hello all, I'm new on this and have a question, I'm looking to have my engine rebuilt soon I have a 2001 vision cx613 I believe a 430 hp but has been turned up to460.When it gets rebuilt can I make the displacement bigger for more hp? I pull 42 ton and would like a little bit more power, any suggestions on the best course of action and where to get the parts from? CheersJohn Quote Link to comment Share on other sites More sharing options...
slpwlker Posted October 27, 2012 Share Posted October 27, 2012 Welcome to the jungle Quote Link to comment Share on other sites More sharing options...
mack mhe9 Posted October 27, 2012 Share Posted October 27, 2012 welcome, with a mack unless you can stuff an E9 V8 in there "trust me you cant" the 12lit mack six is what you get, there are some after market things outthere but im not knowleged, but pepole here are, Quote Link to comment Share on other sites More sharing options...
oilburner Posted October 27, 2012 Share Posted October 27, 2012 Yea like mack mhe9 said you my be able to get some aftermarket parts to beef it up but i have never heard of big bore or stroker kits for the macks, but some turbo and fuel system up grades can help and you could do some software upgrades on the ecm. good luck Quote Link to comment Share on other sites More sharing options...
staxx Posted October 27, 2012 Share Posted October 27, 2012 Not alot you can do if its already a 460 , if you had to have more hp I would go with bigger injectors and turbo upgrades are possiable but then you need to be careful with high exhaust gas temps . If you had unlimited funds Iam sure we could go bigger bores etc. monster motor but this would basically be a race engine . So if you unlimited funds lets get together and I will help you spend your money. What gears and trans are you running do you have a trans cooler ? Quote Link to comment Share on other sites More sharing options...
meca Posted November 8, 2012 Author Share Posted November 8, 2012 Thanks for the info guys and welcomes, yes staxx I do have a tranny cooler on it, sadly no unlimited funds lol the trans is an Eaton 13 spd and not sure about gears, what is the easiest way to find that info out?CheersJohn Quote Link to comment Share on other sites More sharing options...
staxx Posted November 9, 2012 Share Posted November 9, 2012 Scrap the crud off the tag on the rear and see what ratio it has have local mack parts or service dept run your vin and see what it come with from factory is another option. Quote Link to comment Share on other sites More sharing options...
meca Posted November 9, 2012 Author Share Posted November 9, 2012 I will have a look thanks... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.