Jump to content

Transmission Swap


rockyvander
 Share

Recommended Posts

I have a 1960 B61 with a 1984 E6 engine and 6speed with Lo-hole trans , I plan on replacing with T2090 mack 9speed has anyone made that swap and if so how did it go and what parts would I need with the 9speed other than gear shift and air shifter , I am currently using the 84 mack trans mounts with a pull clutch would appreciate suggestions --thanks --Rocky

Link to comment
Share on other sites

I have a 1960 B61 with a 1984 E6 engine and 6speed with Lo-hole trans , I plan on replacing with T2090 mack 9speed has anyone made that swap and if so how did it go and what parts would I need with the 9speed other than gear shift and air shifter , I am currently using the 84 mack trans mounts with a pull clutch would appreciate suggestions --thanks --Rocky

It should be just bolt in other than the driveshaft might have to be longer,the shifter,transmission yoke should interchange,get a high-low splitter from an old roadranger.
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...