SLEDOG

Well I’ve had some good luck fixing my 07 granite on this site so here I go again…

Blower works great but not much at defroster vents when called for.

im taking console apart now and was wondering if there is a flapper or something that I need to check and how do I get to it….

 Thanks Sledog 

I just got done taking grounds of and checking.  Found a couple issues and wired grounds the way they are supposed to be.

 She starts fine and I need to work her and see what happens now I think.

Which relay in glove box will cause me an issue with this… there’s 6 or seven in glove box 

Still chasing original post

I put new crank sensor in and I haven’t actually worked the truck to test yet.

it does stall when cam sensor pulled and I’m led to believe it should not do that….

sledog 

Tjh

yah I didn’t see this post until after I put my foot in my mouth….

dog

Joey 

I understand what you are saying. I’ll have to see if my neighbor has that socket for the tranny and if I can borrow it ….

Sledog

Joey I didn’t see your post until just now on the locating pin on the flywheel.  They couldn’t have got that wrong then …..

sledog 

Joey 

They must have had the flywheel off because I had them put a new main seal on while they were in there since old one was leaking.

so you are saying the flywheel was not indexed when they re-installed it possibly?

This may be an issue I have to take up with shop then….

 If it does need indexing I’ll call the shop and see if they actually did that or not.

 I don’t have that special socket to bar it over anyway…

sledog

Wow that’s a lot…so the ring gear might be on the flywheel wrong? Or slipped? 

how do I know where the 45 degree mark is?

Aftermarket bell housing same flywheel …I had a Local shop work on it 

The new was around 800 ohms…

I don’t if that sensor was good or bad when the housing broke…

No it was starting to have a fish-bite miss before….

Joey…Ok put new sensor in and still shuts down when I pull cam sensor….

is there a way to see if new sensor is picking up teeth on flywheel ?

and I recently had new aftermarket flywheel  housing installed ( Mack had part on Bo).looking in the hole the teeth only cover half …is that ok?

I have 2mm clearance between teeth and end of sensor 

Joey 

the first couple feet look good to where it goes into big loom by the engine 

sledog

Joey 

im only getting about 4 ohms on sensor.

sledog 

Is there a way to test sensor with ohm meter?

No I’m not getting any codes for that 

Joey 

yah motor shut off when I disconnected cam sensor.

looking to get a new one for bell housing now 

thanks a million!!

sledog 

Joey 

Ok thanks I’ll try that tomorrow morning.

sledog 

Joey 

Not sure I totally understand sensor test. Are you saying it should stay running when I unplug one at a time?

And if it does they are both good?

sledog 

I never get a guage and actually check pressure Onyx 

Yes it is onyx 

Ok what pressure should I see?