Farmall1212
-
Posts
10 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
BMT Wiki
Collections
Store
Everything posted by Farmall1212
-
Long ago but is the trailer still for sale? Thanks
-
No what I meant was if the delco pinion from a 39mt would fit the Mitsubishi. I found the correct delco 39mt since this post. Will let you know how it works once I get it installed. thanks
-
Got a 39 mt starter and it is 12 spline Mitsubishi. Anyone know if the Delco pinion fits the Mitsubishi? Price was right.
-
B67 rear end model identification
Farmall1212 replied to Farmall1212's topic in Driveline and Suspension
Which is better single or double? This will be a site truck in The mountains so the lower the ratio the better. How much newer of a rear fits? Do you think the newer style that drop in from the top would fit if I changed the whole axle? I can get one of those cheap. Not looking to put a lot into it. -
B67 rear end model identification
Farmall1212 replied to Farmall1212's topic in Driveline and Suspension
Finally got that measurement. It is 23” from face of the rear to center of the driveshaft. With it being that much space I would think it would be double reduction but would appreciate any help identifying. Thanks -
B67 rear end model identification
Farmall1212 replied to Farmall1212's topic in Driveline and Suspension
Sweet! I do have the driveshaft but it will take me a few days to get it measured. I will post once I get the dimension. Thanks -
Just got a B67 and it does not have the center section in the rear. Axles are there. Any idea where I can find a tag or stamping to determine what I need? Did they all have the same rear just different ratios? I am going to use this as a site truck in the mountains so I don’t need it to be brand new. It does have Mack stamped in the rear cover which is welded on and is not removable is that helps in identifying. Can I swap it out with a newer style that drops in From the top? This one comes in from the front. Thanks
-
What are the differences in each model and should I look for one over another? thanks for the info.
-
Need to swap the old 24 volt starter in a B67 to 12 volts. Someone took the parallel switch so it is either switch alternator to 24 volt or starter to 12. I know it is done, does anyone have a starter model number that the old one crosses to? Old starter number is a Delco 1113700. By my research it crosses to a MT40. Will it drop in or do I need a specific MT40? I am only wanting to be able to crank the engine and have headlights as far as my electrical system goes, it is a site truck In The mountains so I don’t need anything else, I am eliminating everything else. Thanks for any help.
-
New guy here but long time Mack guy. I have a ??? B67 dump truck just acquired, waiting to get the serial number to determine what I have. I also have 2 Allis Chalmers HD5 crawlers, a 1954 in a dozer and a 1953 in TS5 loader, 1941 Farmall A tractor and a 60s vintage Massey Ferguson MF20 with a loader. Nice site here, I appreciate the inclusion.
BMT Forum Logo
