Jump to content

South Dakota pushes speed limit to 80 mph


kscarbel2

Recommended Posts

Overdrive / April 2, 2015

Following passage of bills in the South Dakota state legislature earlier this year that boosted the state’s maximum speed limit, as shown in the tweet above, the S.D. DOT was hard at work prepping for the change. The change took effect on April 1 on I-90 and I-29 in portions of the state.

South Dakota joins four other states with speed limits of 80 or higher: Utah, Wyoming and Idaho at 80 (though Idaho limits trucks to less with a split limit) and Texas in one spot up to 85. With speed limits creeping up, the Associated Press published this story the morning of March 31, which questioned the wisdom of such high speed limits for large trucks.

Before you take advantage of any top truck speed limit above 75 mph, consider that most commercial truck tires are rated for a maximum speed of 75 mph. Long periods running above the max speed may accelerate wear with built-up heat — which could ultimately result in tire failure. Most auto tires, meanwhile, are max-speed-rated much higher.

Bridgestone, for instance, issued a statement this week in response to the AP report, reiterating that most of its long-haul tires carry a speed rating of 75 mph, though some have a speed rating slightly higher — 82 mph.

Michelin spokesperson Tony Fouladpour likewise says most of his company’s on-highway heavy-duty tires are rated at 75 mph, with some being rated for up to 81 mph. However, there are more factors at play than just manufacturer ratings and speed, he says. “Michelin provides commercial customers and fleets very specific and detailed information on the speed rating as it relates to tire pressure, proper wheels and load capacity — all of which are important factors when it comes to tire safety at any speed,” Fouladpour says.

In a quick scan of Goodyear’s online spec options, most of the company’s on-highway truck tires show speed ratings of 75 mph.

Note: More tire manufacturers were consulted for this article. Their input will be added when it becomes available.

Link to comment
Share on other sites

Many tractor-trailers on Texas roads exceed tires’ safety ratings

Star-Telegram / March 31, 2015

Many tractor-trailers on the roads across Texas and the nation are driven faster than the 75 mph their tires are designed to handle, a practice that has been linked to wrecks and blowouts but has largely escaped the attention of highway officials.

Nearly all truck tires have been built for a maximum sustained speed of 75 mph since the middle of last decade, when drivers across the vast majority of the U.S. were allowed to go no faster than 65 or 70 mph.

But 14 states, mainly west of the Mississippi River, now have speed limits of 75, 80, even 85 mph in part of Texas. Some of those states acted without consulting the tire industry.

Safety advocates and tire experts say that habitually driving faster than a tire’s rated speed can generate excessive heat that damages the rubber, with potentially catastrophic results.

“It’s a recipe for disaster,” said James Perham, president of Extreme Transportation Corp., an automobile-hauling company near San Diego that filed a complaint with regulators about Michelin tires after seven blowouts caused an estimated $20,000 to $30,000 in damage to its rigs.

The disconnect between highway speed limits and safety standards was discovered by The Associated Press in a government document that detailed an investigation into truck tire failures.

Last month, the National Highway Traffic Safety Administration closed the investigation into blowouts involving certain Michelin tires after determining that truck operators, not the tires, were at fault. An investigator wrote that exceeding the 75 mph rating was the most likely cause in all 16 complaints examined. The blowouts resulted in three crashes but no injuries.

State officials and the tire and trucking industries point the finger at each other for causing the problem. Highway officials in three states that allow trucks to go 80 mph or more either disregarded tire safety ratings, wouldn’t answer questions about them or told the AP they were unaware of them.

In Texas, a spokeswoman refused to answer repeated questions about whether the state knew about the tire standards before raising speed limits. The sponsor of the law that allowed the Transportation Department to set an 85 mph limit along a new toll road was also unaware of the tire limitations.

“We don’t have any knowledge of this,” said Chris Steinbach, chief of staff for then-Rep. Lois Kolkhorst, now a state senator.

From 2009 through 2013, there were just over 14,000 fatal crashes in the U.S. involving heavy trucks and buses, killing almost 16,000 people, according to NHTSA. Tires were a factor in 198 of those crashes and 223 deaths.

Forty people died in truck tire-related crashes in 2009, and that rose to 52 in 2013, the latest year for which statistics are available.

It’s hard to pinpoint the cause of most blowouts. Road debris can be a factor. Underinflation, heavy loads and high speeds can also damage tires over time.

States set their own speed limits, having been given sole authority to do so by Congress in the mid-1990s, while the federal government, through NHTSA, has authority to raise tire standards.

In Texas, that has translated into a 50-mile stretch of toll road outside Austin with a speed limit of 80 mph from Georgetown to Mustang Ridge — from 25 miles north of Austin to 15 miles south of Austin. There’s also a more recently opened 41-mile stretch, with the nation's fastest speed limit of 85 mph, completing that route south to Interstate 10 near Seguin, about 40 miles east of San Antonio.

The toll road is intended to help alleviate the increasingly crowded Interstate 35 corridor between Austin and San Antonio.

For now, NHTSA contends the most effective way to attack the problem is a regulation to require devices that would prevent trucks from going over 75 mph. But the proposed measure has been stalled for years in a morass of cost analyses and government reviews.

Another possible solution would be for manufacturers to make tires that can handle higher speeds. Some companies already produce a small number safety-rated at 81 mph that cost about the same as those built for 75 mph.

But manufacturers are hesitant to make more, fearing sales won’t be big enough to justify the cost of redesigning and retooling, said Dan Zielinski, spokesman for the Rubber Manufacturers Association.

He said many trucking companies would not be interested in higher-rated tires because they already equip their 18-wheelers with speed governors that prevent them from going over 75 mph.

Michelin sells more truck tires than any other manufacturer, followed by Bridgestone, Goodyear, Yokohama and Firestone, according to Modern Tire Dealer magazine.

The problem does not extend to ordinary car tires. Ever since Firestone tires started failing on Ford Explorers in the 1990s, the government has required car and light truck tires to be designed for well above highway speed limits. Even the most basic car tires can safely go up to 112 mph.

Industry response

The American Trucking Associations, an industry group, says it opposes speed limits over 65 mph, and it has petitioned the government to require speed-limiting devices on trucks.

ATA spokesman Sean McNally provided a 2007 survey done by the group showing that 69 percent of trucking companies already had such devices on at least some of their rigs, with an average limit of 69 mph.

Still, it took federal regulators five years to propose a regulation, and it is still being reviewed by government agencies. It could take months, if not years, to go into effect.

For now, truck drivers keep driving at high speeds — legally and illegally.

NHTSA began investigating the Michelin tires last October after getting complaints about tire failures, mainly from auto-hauling companies. In one case, a truck going more than the 75 mph speed limit on Interstate 10 in Deming, N.M., blew a tire and rolled onto its side.

Of the states that now let trucks travel 75 mph or more, three allow 80 or higher – Texas, Utah and Wyoming. South Dakota is about to raise its truck speed limit to 80, and three more states — Missouri, Nevada and Washington — may go to 75 or higher.

In Utah, the Transportation Department said it didn’t know about the truck tire speed ratings until told by a reporter.

In Wyoming, which raised speeds on some rural highways to 80 mph last July, “it doesn’t look like necessarily there was any consideration of truck tire speed ratings,” said Bruce Burrows, a spokesman for the state Transportation Department. Wyoming hasn’t seen a spike in tire failures, he said.

Burrows also noted that the speed limit doesn’t require truckers to go 80 mph, and said they should be aware of how fast their equipment can safely travel — a common refrain among state officials.

States to blame?

Tire and trucking industry groups blame the states for allowing unsafe speeds, though they say drivers should be aware of tire limitations.

Along Texas Highway 130, which has an 85 mph speed limit for big rigs, driver David Ortiz said he didn’t know about the 75 mph rating for most truck tires, or how fast his tires were designed to go. He said his company has limited the top speed of his truck to 65 mph, and he normally goes 63.

But Ortiz conceded that a speed limit higher than the tires can handle is a safety problem for truckers who drive faster. “Somebody needs to think about it,” he said.

Although many truck operators maintain their vehicles well, NHTSA found a number with problems.

As part of the Michelin investigation, the agency tested trucks and surveyed over a dozen drivers in Pennsylvania, finding that more than half had overburdened tires because of heavy loads or low air pressure. Sixty percent of drivers didn’t know the proper inflation pressure for the trucks they were driving.

To make sure drivers know their tires’ limits, NHTSA is considering a requirement that maximum speeds be listed on the sidewalls of all truck tires.

Truck tires are generally reliable and are responsible for a relatively low number of accidents, said the rubber association’s Zielinski. But he added: “An 18-wheeler is not a Porsche, and shouldn’t be driven like one.”

Link to comment
Share on other sites

Utah needs truck speed limit

Standard-Examiner Editorial Board / April 2, 2015

When Utah and other Western states decided to raise speed limits above 75 mph on highway stretches some officials forgot to consult with an important stakeholder: the tire industry.

Safety advocates and tire experts say that habitually driving faster than a tire's rated speed can generate excessive heat that damages the rubber, with potentially catastrophic results. This is especially true for large trucks which ride on tires rated to go no faster than 75 mph.

Tire industry officials say they are reluctant to redesign the tires because of the increased cost. Instead they recommend that trucks limit their speeds to below the ratings. Some trucking companies have even installed devices to limit the speeds, and others have advised drivers not to exceed the rated limits.

Utah first raised the speed limits on certain stretches of freeways in 2008, and officials have indicated they have seen no data to indicate that the increased speed limits have led to an increase in accidents.

The reason there is no data is because there isn’t any on-going research being conducted at the moment in Utah specifically targeting the 80 mph zones. In fact some officials didn’t even know the limits were above the tire ratings.

That’s a problem.

From 2009 through 2013, there were just over 14,000 fatal crashes in the U.S. involving heavy trucks and buses, killing almost 16,000 people, according to National Traffic Highway Safety Association. Tires were a factor in 198 of those crashes and 223 deaths. Forty people died in truck tire-related crashes in 2009, and that rose to 52 in 2013, the latest year for which statistics are available.

Tire blowouts on large rigs are a safety concern.

There is a solution to the issue, even if it is done on a temporary basis -- have a separate speed limit for trucks.

The state should do more research on the issue, but all the 80 mph zones could have a second lower speed limit for large trucks. Legislator and Utah Highway Patrol trooper Lee Perry says that can be counter productive because if trucks are going slower than cars on a two-lane highway, and one truck tries to pass another, it can cause traffic problems that may result in accidents.

However, we don’t think capping trucks at say 75 mph in a freeway 80 mph zone will contribute much to backup congestion. But it could lead to a decrease in tire failure, which we know is a safety hazard.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...