Jump to content

Governor shaft for EN377


Recommended Posts

While unsticking a governor on an EN377, I used just that little too much force and broke the shaft for the governor plate. It is a straight shaft, no holes except the two for the plate, and a slot machined into the middle for the plate to go through. The plate is 1 7/16" across and the shaft is 3/8" brass (I will check if someone has something close) I can make the length whatever I need. I hate to cannibalize a working truck, but I figure there is an old carb on someone's shelf that will have a close enough shaft. Thank you..

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...