indyandy

OK guys, I'll look again. I'll check it out a little closer. Thanks for all the good advice!!!!! Andy.

I found a metal tag on intermediate axle. Hays-Dana inc. 19QF 4414. Cast in to top, Mack 64KH 5104. Is the metal tag from a rebuild? Any one know what these mean? Thanks ANDY!

Good info, thanks Challenger!!!

Hey all, I have a 1994 ch 613 with 40k Mack top loaders, 4.17 ratio according to vin. Rear axle throwing oil out of pinon seal, shaft is loose,maybe 1/8 to 3/16 movement. Wanting to get a manual off e bay, but need to know which book to order.How do you ID which axles I have? Apparently there has been some issues as new rear drive shaft and u joints and yolk. It was used as an in plant tractor so who knows how well maintained. Thanks, Andy.

Hi all, terrific website here! Just got a ch 613 tractor,twin screw,all mack, E7 350HP. It has 22.5 rubber, but is on 8 lug budds. Never seen this before, is this a lighter duty set up? Wanting to use it for a lowboy tractor, cant find GVW weight, is it in the ser. #? Wanting to pull a 50 ton rgn,tri axle with a 84000+ dozer, real local, less than 50 mile. THANKS in advance and GREAT to be on this website!!!!!!!!