Jump to content

sambo's Blog

  • entry
    1
  • comments
    2
  • views
    6,769

E7-350


tracey

1,359 views

 Share

I recently did an inframe rebuild on a 2000 model E7-350 engine. Oil blows out the breather tube at high RPM's. I used an aftermarket kit with new liners, pistons and rings. We even let the truck run for several hrs at 1700 rpms to try to seat the rings. There is still to much blow-by. Could this by anything besides a piston ring problem?

 Share

2 Comments


Recommended Comments

The best way to bed new rings or run in a new motor is to load the engine up and run for as long as possible, ie a long trip. running the engine at highish rpm unloaded is counter productive and may even glaze the bore.

Short story, make them work.

Good luck

Link to comment
Guest
Add a comment...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...