Jump to content

Mack vision egt senor not working.


Recommended Posts

Good day. Got a 2005 mack vision equipped with the aset engine. Got a 3-1 code for exhaust temp senor. At engine start up the gauge cycles with the rest of the gauges but does not move after that. I replaced the sensor, still does not work. Followed wires back into cab to the connector behind the radio, unplugged harness there and checked voltages. I am getting 1.8 volts on both pins. Anyone know what I should be seeing here for voltage? Also tested new and old sensors on the bench with heat gun and ohm meter and both seem to be operating the same. Any help would be appreciated.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...