Jump to content

Crankshaft Specs E-7 350


Recommended Posts

I am trying to find the crankshaft specs for my 1991 E-7 350 Mack says the rod journals are suppose to be at 3.248 mine are at 3.332 with std. bearings,I plastigaged the new bearings at .003 to .004 "what am I missing here" this is about .015 diffrence it's been running like this for over 200,000 miles the Motor was remaned by Mack the new bearings have the same numbers as the old ones,I had a machine shop come out to measure the crankshaft

Link to comment
Share on other sites

This is from the E7 Manual. I've seen instances when the manual didn't have the correct measurements listed. Assemble the rod, bearings, and cap and measure the bearing ID with an inside micrometer or a "snap" gauge and outside micrometer and compare to your measurement for the crankpin to verify that you have correct running clearances.

CONNECTING ROD

Length between centers 10.4375 in. 26.5113 cm

Cap angle 35 degrees

Bore for bushing 2.4355–2.4345 in. 61.8617–61.8363 mm

Burnish bushing to 2.2305–2.2275 in. 56.6547–56.5785 mm

Finish bore to 2.2504–2.2500 in. 57.1602–57.1500 mm

Crankpin bore diameter — as bored 3.4305–3.4297 in. 87.1347–87.1144 mm

— reassembled 3.4309–3.4294 in. 87.1449–87.1068 mm

Bearing ID in place 2.9993–3.0013 in. 76.1822–76.2330 mm

Journal clearance 0.0012–0.0054 in. 0.0305–0.1372 mm

Side clearance 0.007–0.014 in. 0.1778–0.3556 mm

Twist within 12 inches (30.48 cm) 0.010 in. 0.254 mm

Bend within 12 inches (30.48 cm) 0.004 in. 0.1016 mm

CRANKSHAFT

Crankpin journal OD 3.248–3.247 in. 82.4992–82.4738 mm

End play at No. 4 main 0.004–0.013 in. 0.1016–0.3302 mm

Main journal OD 4.4974–4.4964 in. 114.2340–114.2086 mm

Journal out-of-round or taper (maximum diameter) 0.00035 in. 0.00889 mm

Max. Runout at No. 4 journal (shaft supported on No. 1 and No. 7) 0.007 in. 0.178 mm

"Mebbe I'm too ugly and stupid to give up!"

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...