duelly5566
-
Posts
4 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
BMT Wiki
Collections
Store
Everything posted by duelly5566
-
I left my truck running over night because of extreme low air temp outside 0-2 degrees, I wanted a warm engine when I worked on replacing the starter, so I got to the truck after it idled for 13 hrs shut the truck off and was working on it when it came time to go under the truck I found oil dripping from the pipe where the flex goes to the hard pipe just above the frame and all over the leaf spring any help would be great 2001 vision E7 427 with 620,000 on it. Thanks in advance. Steve
-
I left my truck running over night because of extreme low air temp outside 0-2 degrees, I wanted a warm engine when I worked on replacing the starter, so I got to the truck after it idled for 13 hrs shut the truck off and was working on it when it came time to go under the truck I found oil dripping from the pipe where the flex goes to the hard pipe just above the frame and all over the leaf spring any help would be great 2001 vision E7 427 with 620,000 on it. Thanks in advance. Steve
-
2000 vision fan clutch is always on I checked for voltage and ground constant 12 volts to air switch no ground jump to ground fan stops and then the volt symbol on dash comes on un hook jumper and fan comes on and volt symbol goes out need some help please.
-
this problem has just started, any help would I would be very grateful I have a 2000 ch613 with a 427 and at start up it shows 30 psi and with out moving the truck when you rev up the engine the oil pressure drops down to zero and it almost act's like a rheostat losing a little and then more the more you push down on pedal till about 1400 rpm and hits zero? just thinking maybe sending unit but cannot see one. Thanks for any help in advance
BMT Forum Logo
