No1eaglefan

The nut on the inside of the door on my ch has broken off. From looking behind the interior panel through the speaker hole and pulling the bottom out some I don’t see any way to get to it. Any suggestions?

I’m looking for a replacement MP7 04EPA. I found one My engine is a MP7-405M 370HP@2100RPM And the engine I found is a MP7-395C 370HP@1950RPM Can anyone tell me if it would work with my ECM?

Is this still available

I have a 2007 ctp713 with the non dpf 04 compliant mp7 engine. Oil pump went out and engine is shot. Anyone know if I can install a newer MP7 and delete the dpf. Or what us the best option because I haven’t had any luck finding an engine.

I’m looking at buying a wrecked truck and they don’t have pics of the motor and I was wondering if someone could run the vin and see if it’s an 04 compliant MP7. The vin is 1M2AT04C77M006098 TIA!!

I’m thinking it must be spindle as well do you think the axle surgeon or someone like that could fix it or would I need to replace the whole axle hosing?

So my driver found an old septic tank a while back. We had to replace the trunnion shaft and replaced all the spring pads and everything. Today after getting it back together we noticed the front axle on the passenger side is still looking bent. We jacked it up and spun the tire and it doesn’t wobble or anything it stays on the same plane when spinning. What else could it be we pulled the axle and it doesn’t appear bent. Could the axle housing be bent? What are your thoughts on what it could be.