Triple D

So I've decided to go ahead and have axle surgeon come out to replace the tube . I appreciate all the insight. And yes taking the weight off is the best way to get that grease all the way around the tube and saddle.

Sup Joey! So it's a garbage packer with bronze bushings . When removing the saddles I was able to see that the bottom of the trunnion tube looked like a cheese grader . I know there is a way of splitting the bottom of the trunnion stand where the spindle goes thru to remove it than welding threaded flanges on to clamp the new one in place but not sure if that's a legit way of doing that. Would rather press out the old one without removing the whole stand from the truck . Just looking for the best way

Good morning . Going to be replacing trunnion spindle on a camelback. I have 50ton press and pump but need the rest of the set up to remove and install new trunnion. Is there a place I can purchase this set up or does it need to be fabricated ? Any help would be greatly appreciated