Jump to content

Mack Hammer

Puppy Poster
 View Profile  See their activity

  • Posts

    24

  • Joined

  • Last visited

 Content Type 

Everything posted by Mack Hammer

  1. Mack Hammer
    I removed the top radiator hose, air charge hoses and support brackets and leaned the radiator forward and still did not have enough room to remove the fan. The A/C lines where pulled tight once I removed them I could lean the radiator forward enough to barely get it out. Dumb setup !! I appreciate the response for help.
  2. Mack Hammer
    Do I need to pull the radiator to get the fan and fan clutch out ?
  3. Mack Hammer
    Rite on. I appreciate the feedback
  4. Mack Hammer
    yes electric, but no programing done on the computer
  5. Mack Hammer
    yes 2007 CV713 Granite AI400
  6. Mack Hammer
    AI 400
  7. Mack Hammer
    yes truck is doing good on temp
  8. Mack Hammer
    Binary is on top of receiver drier. high pressure is green and on the high side steel line. Pretty sure two different switches. Gonna check it out tomorrow for sure. My driver takes the truck home with him
  9. Mack Hammer
    appreciate the advise jojo
  10. Mack Hammer
    will try the binary switch and see what's going on with it. someone else suggested high pressure sensor/switch could cause it to do this.
  11. Mack Hammer
    Does everyone's fan run when truck is at 100 degrees ??
  12. Mack Hammer
    It is robbing my horse power and causing seriously bad fuel economy.
  13. Mack Hammer
    I changed green high pressure switch but didn't help.
  14. Mack Hammer
    fan on non stop all day is not normal ?? turn A/C off and the fan goes off
  15. Mack Hammer
    don't think fan should kick on until temp is over 180 degrees
  16. Mack Hammer
    coolant fan runs full time with A/C turned on
  17. Mack Hammer
    Changed green high pressure switch on A/C line. Sadly didn't fix my problem.
  18. Mack Hammer
    Everything went well. Snap ring was missing on forward side of shaft, and end plug was out and stuck to the front wall of rear box. A shout out to everyone who gave me advise. Much appreciated.
  19. Mack Hammer
    Nope single stack right side only thank god. so assuming cover is on driver side
  20. Mack Hammer
    Gonna give this a whirl tomorrow. I appreciate everyone's input on this. The pic is great. I just made a profile on this website today and I'm liking the help. Thank You
  21. Mack Hammer
    Yes 2007 Granite CV713 And yes 6'3" 260lbs not a little fellow 🙂
  22. Mack Hammer
    Can this be done with trans in the truck, or does it need to be removed ?
  23. Mack Hammer
    yes multispeed reverse (all low range gears) with yellow reverse selector lever
  24. Mack Hammer
    T310M Trans will not come out of reverse and is blowing air into tranny case

BigMackTrucks.com

BigMackTrucks.com is a support forum for antique, classic and modern Mack Trucks! The forum is owned and maintained by Watt's Truck Center, Inc. an independent, full service Mack dealer. The forums are not affiliated with Mack Trucks, Inc.

Our Vendors and Advertisers

Thank you for your support!

Mack Related Links

Popular links

BMT Forum Logo

HTML tutorial
×
×
  • Create New...