markrandi
-
Posts
25 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
BMT Wiki
Collections
Store
Posts posted by markrandi
-
-
2006 mack granite city horn inoperable. All parts are present but can't figure out how the wire to the horn connects to contact plate on steering wheel.
-
Do u smell diesel fuel? COULD be cracked inj cups.
-
Where is the a/c hi spd relay/fuse located on a 2000 RD688S?
-
How do u remove #6 inj from an mbe 900 mercedes with the head on the engine in the truck?
-
Location of oil level sending unit on 2007 granite with an mp7?
-
TY, Sir! This is a single nut that has 2 small allen screws opposite each other that turn into a lock plate. I'm glad I asked. I was going to go 100-150 after pre-loading.
-
What are the torque specs for the drive axle wheel bearings on a ctp 713.
-
Where is the low air pressure sw located on a 2001 RD688S?
-
Using the rr main install tool on a 2007 MP7 how deep should the seal go?
-
On 1/2/2018 at 11:09 AM, markrandi said:
Truck is a 2007 with a Maxitorque transmission.
-
What's involved in pulling the bellhousing off an 07 MP7 inframe?
-
Truck is a 2007 with a Maxitorque transmission.
-
Will find out tomorrow when I go back to work.
-
Mack tranny-10 spd. Looks like input shaft just slides in. Am I right or wrong?
-
I took the input shaft out to replace the gasket. Anything special I should know before I put it back in?
-
How do u rplc front trans seal on mack 10 spd? Does the input shaft need to come apart?
-
How do you replace transmission input shaft seal?
-
Ho
-
T.s. sw has been replaced. Has dimmer in it. Wondering if there's a hi & lo beam relay?
-
Where can I find a fuse panel diagram for a 2000 rd688s? No hi-beam headlights.
-
2007 mack mp7 granite. Code is p173 m140 01 05f. Yellow lightning bolt on constant. Red shutdown lt comes on & off intermittently. Rplc maf sensor per dealer & egr temp sensor. No difference. Any help would be appreciated.
-
1 hour ago, markrandi said:
I took the bolt out of the retainer & tried that. No luck. I didn't want to force to much.
After re-reading ur post I saw what I was doing wrong & was able to git er done. Ty!
- 1
-
On 4/13/2016 at 7:55 PM, MackTech said:
Just the tube from the oil pan, is just like an airline. Push the retainer towards the oil pan and pull the tube out.
I took the bolt out of the retainer & tried that. No luck. I didn't want to force to much.
-
How do u remove the oil dipstick tube from an mp7?
City Horn
in Mack Truck Q & A
Posted
Ty. That's what I thought but Nextran keeps telling me it's just a button, spring & plate, nothing else. They can't find a contact on the computer. I've since gone to a different dealer in a different part of the state who said they ordered it. The horns work if I ground the wire that the spring contact goes to.