-
Posts
43 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
BMT Wiki
Collections
Store
Posts posted by Mike Donohue
-
-
Oil sample
-
$1500 price drop ! Sister truck needed steer tires over the weekend before rolling out so price has dropped accordingly to offset the cost to replace with a really nice set of your choice .
-
22 hours ago, Big Mack Truck said:
Truck still for sale?
Yes it is !
-
9 hours ago, james j neiweem said:
Jesus be with you Mike.
Thank you !!!
-
7 hours ago, hatcity said:
No Rob. I just drive for a local sand company. Basic maintenance (grease, oil changes) is all I do. no more brakes, u-joints, carrier bearings, radiators, fan clutches
And I got rid of all my tools
thanks for asking....and i'm doing good so far
Great to see things are working out for you !
-
8 hours ago, Mack Technician said:
GOD IS GOOD Mike! Hope He blesses you with recovery.
Thank you so much !
-
E-7 460 with a 9 speed Eaton-Fuller.
-
I forgot to mention I put three new 925 batteries in it at the beginning of the year and it was getting 6.0 - 7.8 MPG with both a van or Flatbed.
-
43 minutes ago, Dirtymilkman said:
Sorry to hear about the cancer.
Thanks man ! We are going to beat it like a red headed stepchild ! Going for the 3rd treatment out of 12 on Tuesday. Greatly appreciates the shout out !
-
Ugly but great running and reliable truck ! I've taken this to every corner of the country this year and only selling due to a stage 4 cancer diagnosis, so not quite sure about if or when I might be returning to driving.
The good, parts that have been replaced with less than 35,000 miles on them:
New Steer tires
Good drives
new clutch
New rear torque arms
New rear brakes , drums, pads & seals , front are good
What it needs now , at least in my opinion:
New Air Dryer (current is bypassed)
A/C is not working , jumped the compressor and it kicked in , just ran out of time to fix.
Both vent windows need replaced , driver side took a pellet going thru Shreveport LA the passenger side pivot is broke at the top, passenger window does not roll down.
Door panels are off, because I was replacing some of the clips inside for the door linkage
A good deep cleaning , replace the hood (Current one has far more dings than I care to deal with) and paint.
I will be pulling an oil sample to share,
$15,000 located an hour north of Tampa FL
Best way to contact me is via email at rydermike02@hotmail.com
-
If I start the truck (Cold or warm) the heat will not work, sometimes the temp gauge goes up enough to kick the fan on although the air is cold blowing thru. Odd thing is , once you go a few hundred yards all is good. Is the thermostat sticking? Why would it suddenly open from moving a short distance? 1999 CH613
-
Loves Aeolus tires are a great value as well, I bought them before and will be buying a couple steers in the afternoon!
-
Being new to a Mack , one of the things that no matter the horsepower is the fact the Mack power curve is very flat and will never "feel" like you are accelerating. One of the first issues when new to the brand for many!
-
Does anyone have a copy of the fuse panel identifying each fuse? My reverse light isn't working because there is no power to the sensor.
-
13 hours ago, Glensts said:
If you tap the dash to the right and below the speedometer, thats where the buzzer is. Quite often ours quit but start once you tap where the buzzer is situated
Might make sense ! This truck was parked for a year or so , might just be stuck! Thanks !!!
-
Reverse light and low air alarm are not operable on a truck I just bought , any suggestions , before I overlook the obvious ? Also is there anything special to wire for the trailer ABS light to work properly?
Thanks in advance !
-
Any good places to look for a handheld scanner where I can check codes and change settings
-
Looking for grey CH door cards .
-
Maybe rebuild to the E-7 marine spec engines, although is seem's very difficult to find info on them thesedays.
- 1
-
Chicago , Joliet , Indiana Mack and the small satellite shops were great when owned by Shelby , bit no longer. While I don't get thru Tulsa much ,I always appreciated Tulsa Mack! If I had the cash to buy the 2000 Vision there right now I would !
-
Still available?
-
Whats it weigh with no trailer and a half tanks of fuel?
-
Throttle ! I 25 year rule gets vehicles past EPA issues and I don't think those would apply to heavy trucks anyway.
-
I've always wanted to have one with lit up eyes , THEN have a spring loaded right leg that will lift when I hit a button to make it lift it's leg and piss on Peterbilts when hooked to a windshield washer pump!!
- 1
1999 CH 613 Sleeper truck
in Trucks for Sale
Posted
$10,000 buys it now! 3/4 the way thru cancer treatments, if I still own the truck after the beginning of the year , I will put it back in service!