Macktech689
-
Posts
182 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
BMT Wiki
Collections
Store
Everything posted by Macktech689
-
sorry to say I already have one, I keep it in my toolbox right next to my magic wand and x-ray glasses.
-
1994 + 1995 Ch 600s hard starting
Macktech689 replied to Bj Hinson's topic in Engine and Transmission
Check all the return fuel lines from the heads to the injection pump, they look like small plastic air lines. any leaks cause loss of prime. Also check the jumper between the heads by the valve covers -
North Carolina
-
Mp7,8 rocker assembly tourque spec.
Macktech689 replied to Kyle 537's topic in Engine and Transmission
Should have also mentioned to make sure all the oil collected in the bolt holes is removed and to make sure the rocker shaft is pulled down tight against the cam blocks before torqing the bolts -
Mp7,8 rocker assembly tourque spec.
Macktech689 replied to Kyle 537's topic in Engine and Transmission
Yes Kyle the trim code for each injector needs to be programmed in the ECM, also a learned data reset should be done. Injector torque procedure is 15 FT pounds + 180 degrees then loosen to 7 to 11 FT pounds retorque to 15 +90 degrees. MP7 rocker bolts 44 FT pounds + 100 degrees. MP8 rocker bolts the 12 small bolts are 18 FT pounds +120 degrees, the big bolt is 44 ft pounds + 120 degrees. Hope this helps RM. -
I am a service tech at a Mack dealership in the Southeast US, Hopefully I can help some of you guys out from time to time. Have been repairing Macks since 1987.
-
VMAC 1 has 2 modules, the VECU monitors vehicle functions and the FIC controls fuel injection. Both " should" both disconnected before any welding operations, but removing the battery grounds is usually sufficient. Keep in mind control modules and programming for older trucks is very expensive.
BMT Forum Logo
